Edit From A Camcorder - JVC 1204MNH-SW-VE Instructions Manual

EDITING
70
EN

Edit From A Camcorder

You can use a camcorder as the source player and your unit as the
recording deck.
A If the camcorder has no S-VIDEO output connector:
To [VIDEO/AUDIO
((MONO) L/R)] input
Audio/video cable
(not supplied)
Player
B If the camcorder has an S-VIDEO output connector (HDD
& DVD deck only):
To [S-VIDEO]
To [AUDIO] input
input
S-video cable
(not supplied)
Player
Recorder
AUDIO/VIDEO OUT
Recorder
Audio cable
(not
supplied)
S-VIDEO OUT
AUDIO OUT
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Make connections.
A If the camcorder has no S-VIDEO output connector:
^ connect the camcorder's AUDIO/VIDEO OUT connectors to
the unit's [VIDEO/AUDIO ((MONO) L/R)] input connectors
on the front panel.
●
When using a monaural camcorder, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
B If the camcorder has an S-VIDEO output connector: (HDD &
DVD deck only)
^ connect the camcorder's AUDIO OUT and S-VIDEO OUT
connectors to the unit's [AUDIO] and [S-VIDEO] input
connectors on the front panel.
2
Press VHS/HDD/DVD SELECT on the unit repeatedly to select
the recording deck.
3
Press PR +/– to select AF-1B.
●
Set AF-1 INPUTB to AVIDEOB for the [AUDIO] input connector, or
AS-VIDEOB for the [S-VIDEO] input connector, depending on
the connector being used. (A pg. 73)
4
Press REC MODE repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press R on the unit to start recording. Or while holding R, press
I on the remote control. The dubbing starts.
7
Press o on the unit, then stop playback on the camcorder.
NOTES:
●
All necessary cables can be obtained from your dealer.
●
Refer to the camcorder's instruction manual for operating
procedure.
●
The quality of dubbed picture becomes poorer than that of the
original.