Removing Bake Burner Igniter; Removing Bake Burner (Self-Clean Models); Removing Burner Heat Shield (Self-Clean Models) - Electrolux Next Gen 30" Service Manual

Burner baffle nut and two screws
Removing oven burner igniter:
1. Disconnect electrical power from range.
2. Remove oven bottom and burner baffle.
3. Remove the two screws holding the igniter to the
burner.
Igniter mounting screws
4. When replacing the igniter the replacement igniter
will come as a kit. The kit will have an igniter with
short wires and two ceramic wire nut. It will be
necessary to cut and splice the wires.
Replacing the oven burner (self clean models):
1. Disconnect electrical power from range.
2. Remove oven bottom, burner baffle and bake igniter.
3. Remove one screw holding the burner to the rear
oven liner and one screw holding the burner to the
front frame.
Self-clean oven burner mounting screws
Removing burner heat shields (self-clean models):
1. Disconnect electrical power from range.
2. Remove oven bottom, burner baffle and storage
drawer.
3. Remove the four screws holding the lower heat shield
to the oven liner sides and pull the shield out the
front.
Heat shield screws
4. Remove the six screws holding the middle baffle to
the rear and front frame of the range and slide the
baffle out the front.
104