Table of Contents
Advertisement
Press CHANNEL 5 / ∞ (or CH + / –) to select
unnecessary information (PDT), then press
SELECT.
It will be replaced with the new information.
• Cancel: Not to store a new information.
The original screen will be resumed.
How S-Seek function works
Each time JVC PnP is turned on, it automatically
searches the incoming signal to determine if a match
exists between the signal and the PDTs stored in
memory (except the ones with "S-Seek" set to "Off":
see the next page).
• If one or more matches are found, "S-Seek Alert"
appears for a while, and a beep tone sounds.
Play of the current selection will continue until a
new selection is made.
Then the S-Seek Alert List screen which displays
the current matches appears.
• Press CHANNEL 5 / ∞ (or CH + / –) to select
the Artist/Song Title on the S-Seek Alert List
screen, then press SELECT.
Note: If no operation is done for about 10
seconds, JVC PnP automatically exits from the
S-Seek Alert List screen.
To delete or deactivate the PDT for S-Seek
1. Press and hold MEMO for about 3 seconds.
The most newly stored information appears on the
display.
To be continued...
21
Advertisement
Table of Contents
