Bosch D6600 Operation And Installation Manual page 30

D6600 | Operation and Installation Guide | 15.0 Troubleshooting Guide
Table 10: Hardware Troubleshooting Guide (continued)
Problem Symptom
D6200 cannot D6200 network connection is
connect to the defective, missing, or has
D6600 through a
incorrect network cable.
network connection.
D6200 cannot D6200 network connection is
connect to the defective, missing, or has
D6600 through a incorrect network cable.
network connection.
D6200 cannot D6200 network connection is
connect to the defective, missing, or has
D6600 through a incorrect network cable.
network connection.
30
Solution
•
Ensure the Ethernet connection light on the network interface
module for the PC running D6200 Software is on. This
indicates a good network connection.
•
Ensure the Ethernet connection light on the D6680 for the PC
running D6200 Software is on. This indicates a good network
connection.
•
If using the D6600's COM4 to connect to the D6680, ensure
Menu Item 6.1.4 COM4 Network Adapter in the D6600 is set
to 1.
•
If using the D6600's COM1 to connect to the D6680, ensure
Menu Item 6.2.5 COM1 Network Adapter in the D6600 is set
to 1.
•
If communicating within the same LAN, the IP address of the
PC running the D6200 software must be entered into the
D6600 Menu Items 6.4.1 IP Address 1, 6.4.2 IP Address 2, or
6.4.3 IP Address 3.
•
If communicating over a WAN, the external IP address of the
LAN with the PC running the D6200 software must be entered
into the D6600's Menu Items 6.4.1 IP Address 1, 6.4.2 IP
Address 2, or 6.4.3 IP Address 3.
•
Ensure Menu Item 6.4.5 Network Programming Enable in the
D6600 is set to 1.
•
Ensure that the D6200 programming software is set up for
TCP/IP network connection (select Administration
Connection Settings).
— If communicating on the same LAN, ensure the IP
address of the D6680 is entered correctly.
— If communicating over a WAN, ensure the external
IP address of the LAN with the D6680 is entered.
— Both port numbers match (valid ports are from
2001 to 9998).
•
If encryption is enabled on the D6200,
— it must also be enabled on the D6680.
— the 16-byte key must be the same in the D6680
and the D6200 software.
•
If communicating over a WAN, the firewalls of the LANs must
be configured correctly.
For example, the D6680 resides on one LAN while the D6200
software resides in another LAN. A WAN connects them both
but the firewalls at either LAN need to allow TCP and UDP
packets through.
•
Firewalls must allow your selected ports to pass through.
•
Contact your IT administrator.
Bosch Security Systems | 2/05 | 4998122704E