Bosch Integral TH13 Operating Instructions Manual page 125

O
Outgoing ext. line code
Enter the external code that you normally use for external calls.
Outgoing sensitivity -
This function permits you to adjust the sensitivity for the handsfree mode to
better adapt it to the surroundings. The best is to use the lowest possible
setting.
If your telephone is equipped with a deluxe handsfree unit you can also use
this function to vary the echo and the amplification. A higher level results in
an amplification of the microphone signal. If required please contact your
BOSCH TELECOM Service.
Own number
Allocation: You can store your own call number so that it is shown on the
display.
P
Parity for AT command
This function permits you to set the parity for the control of your telephone.
Available settings are „None", „Even" and „Odd".
This option only appears only if you have set the AEI mode of operation to
"AT command".
Participating in a group line
You can switch your phone in and out of a hunt group. This function must
be enabled by your BOSCH TELECOM service representative.
Partner
– You can divert calls to other partners, deactivate diversions, have calls
for another partner indicated on your telephone and change the partner
display.
– All entries assigned to a partner key are shown on the display.
If in doubt, look it up
Menu items on the display "
125