Table of Contents
Advertisement
Before starting
WARNING! Note the following before
!
starting:
The machine should be connected to an
earthed outlet socket.
Check that the mains voltage corresponds
with that stated on the rating plate on the
machine.
Make sure you have a secure footing and
that the cutting blade cannot touch anything.
Keep people and animals well away from the
working area.
K3000 Wet
WARNING! The machine (Great Britain 120V)
!
is not equipped with a ground fault circuit
interrupter. The machine must always be
used with an isolating transformer for
protection in case an electrical fault should
occur.
Water connector
•
Connect the water hose to the water supply (A).
The water is switched on and off with the water tap (B).
STARTING AND STOPPING
Starting
•
Grip the front handle with the left hand.
•
Grip the rear handle with your right hand.
•
Press in the power switch lock with your right-hand thumb
and press in the power switch.
•
Run the machine unloaded and in a safe manner for at
least 30 seconds.
Stopping
WARNING! The cutting blade continues to
!
rotate for some time after the motor has
stopped.
Stop the motor by releasing the power switch.
– 15
English
Advertisement
Table of Contents
