Maintenance; Maintenance Schedule - Husqvarna Rider Pro 18 Operator's Manual

The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.
= Described in these instructions.

Maintenance

Check for fuel and oil leakage
Check the parking brake
Check the engine oil level (when you
refuel)
Check the fuel pump air filter
Check the seat safety switch
Check the lift lever safety switch
Check the parking brake safety switch
Check/clean the engine cooling air intake
Check the cutting unit:
• blades are secure
• condition of blades (sharpness,
shape, etc.)
• blade synchronisation (90° between
BioClip)
Check steering wires (for play, etc.)
Check fasteners (screws, nuts, etc.)
Start engine and blades, listen for noise
Clean underside of cutting unit
Clean transmission air intake
Check battery acid level
Check transmission oil level
Check the condition of belts, pulleys, etc.
Check for damage
Check tyre pressures (60 kPa)
Check for damage to wire guide at
articulated joint
Clean the area around the engine
thoroughly
Clean carefully around the muffler
Clean thoroughly around transmission
Clean all belts, pulleys, etc.
Lubricate belt tensioner (nipple)
Lubricate triangle link
Lubricate the driver's seat
Lubricate all wires
Lubricate bearing surfaces on cutting unit
Clean inside frame tunnel
Lubricate pedal mechanism inside frame
tunnel
Lubricate the gear lever
Lubricate the parking brake wire
Lubricate throttle control
MAINTENANCE

Maintenance schedule

= Not described in these instructions.
Page Daily main-
tenance
before after
-
16+19
61
36
41
41
41
39
53
53
53
53
33
-
-
50
36
40
63
-
-
43
-
39
39
36
57
60
59
59
57
57
-
58
62
63
60
Maintenance interval in
At least
Weekly 3)
hours
once a
main-
25
year
tenance
50 100 300
29
English –