Table of Contents
Advertisement
DBS
FF-1 System mode
SECTION 400 (Version
3.0)
Issue 1 January
1990
3 - I - 5 DISA ID Code mode
FFl-5#-(0000
- 9999)#
DISA ID code storing
(Direct
inward
System
Access)
Use of the DISA function
allows
for DID (Direct
in
dialing)
from outside'the
system and DISA
outgoing
call (making
a call on a different
line via
the system from outside).
If *is
ID code is not set then system accept the
DISA call withoutthe
input
ID cod, It also enables
remote
maintenance
through
a telephone
circuit
by the installer
of the system.
Forthese
operations
it is necessary
to input
the
exclusive
DISA code followed
by the remote
maintenance
code, DISA outgoing
call code, etc.
IC~NF~A:
Clear
data
(0000 - 9999)#:
The DISA function
can be used
according
to the stored
code.
Note:
To enable
the use of the DISA function
it
is
necessaty
to set the exclusive
DiSA line to
an outside
line
port separately.
3 - ? - 6 DISA Outqoinq
Call ID mode
FFl-6#-I#-(0000
- 9999)C
DISA Outgoing
call ID code 1 storing
By inputting
the stored
code when
DISA is
operating,
it is possible
to make a call from a
different
line via the system from outside.
For using this function
an
code is stored.
[CONF]#:
Clearto
data (Initial
= 1111).
(0000- 9999)#:
To enable
the use of the DISA
function
it is necessary
to set the
excfusive
DISA line to an outside
line port separately.
FFl-6#-Z#-(OOOO
- 9999)#
DISA Outgoing
call ID code.2
storing
By inputting
the stored
code when
DISA is
operating,
it is possible
to make a call from a
different
line via the system from outside.
For
using this function
an code is stored.
[CONF]#:
Clear to data (Initial
= 9999).
(0000- 9999)C:
To enable
the use of the DISA
function
it is necessary
to set the
exclusive
DISA line to an outside
line port separately.
3 - I- 7 System proqram
ID code mode
FFl-7#-(0000
- 9999)#
System
programming
ID code storing
Normally
system programming
is oniy possible
from the attendant's
phone.
But by inputting
this code, the system can also be
programmed
from another
extension.
The code is stored for the system. As the program
is the most part of the system, always be sure to
record
it in the setting
table
(Section
450) and pay
sufficient
attention
when
dealing
with the codes.
The codes already
set can be deleted
with the
[CONa
key.
[CONF]#:
Clear to data (Initial
= 9999).
(0000 9999)#:
System can be programmed
according
to the stored
code.
Note:
Another
extension
telephone
can't program
before
the extension
telephone
which
programmed
cancel the programming
mode.
-2%
Hide quick links:
Advertisement
Chapters
Table of Contents
