MDS 05-4846A01, Rev. C
POWER SUPPLY
10.5–16 VDC @ 2.5A
Negative Ground Only
Figure 10. Typical Remote Station Arrangement
4.1 Mounting Options
The transceiver is normally provided with flat mounting brackets
attached to the bottom of the radio as shown in Figure 11. An optional
35mm rail mounting bracket is also available, and is described below.
Figure 11. Mounting Bracket Dimensions
NOTE:
To prevent moisture from entering the radio, do not mount the case
with the cable connectors pointing up. Also, dress all cables to
prevent moisture from running along the cables and into the radio.
SD Series Ref. Manual (Packet & Transparent Mode)
ANTENNA SYSTEM
Master Stations typically use
omni-directional antenna
TRANSCEIVER
OR:
DATA TELEMETRY DEVICE
OR HOST COMPUTER
Invisible place holder
6.675˝ (16.95 cm)
13