Opt; Owm [Xxxxx]; Own [Xxxxx]; Prog - GE MDS 4790M Installation And Operation Manual

MDS 05-3628A01, Rev. B
Entering the command alone displays the current setting of minor
NMASK
alarm events in hexadecimal format. Entering the
by an eight-digit hexadecimal number reassigns each of the 32 possible alarm
events as enabled or disabled, with respect to minor alarm output relay status
and switchover criteria.
The hex value for the mask corresponds to the hex value for the
command (see the
ALARM
identifies the associated alarm event as a major alarm. Each bit that is a '0'
means that the alarm condition will not cause an alarm output relay to be
asserted, and will not cause a radio to switch over.
For more information on configuring the alarm response, contact GE MDS and
request Application Bulletin 98-002.

OPT

The command lists each upgradable option and shows whether it is
OPT
installed ( ) or not installed (
ON
The output format is as follows (note that
this value could be either
Diagnostics
Premium Options: OFF
Digital Modem

OWM [xxxxx]

The command allows for display or entry of an optional text message
OWM
such as the system name. The entry can contain up to 30 characters.

OWN [xxxxx]

The command allows for display or entry of an optional text message
OWN
such as the site name. The entry can contain up to 30 characters.

PROG

This command reprograms the radio's operating software. On redundant
master stations, this command reprograms the standby unit; the active unit
must then be programmed using
the active unit the standby unit and then reprogramming it. (It can then be
switched back to standby operation, or left as the active radio.)
Reprogramming instructions can be found in the on-line help included in GE
MDS' Radio Configuration Software (P/N 03-3156A01).

PROGACT

On redundant master stations, this command can be used to force the active
radio to be programmed. Normally, if reprogramming is required, the standby
radio is programmed while the active radio maintains normal system operation
(see above).
PROG
MDS 4790M (MPT 1411) I/O Guide
command description). Each bit that is a '1'
).
OFF
represents the current setting;
OFF
or ):
ON OFF
: OFF
: OFF
Set Owner Message screen,
page 60
Set Owner Name screen,
page 59
(described below), or by making
PROGACT
command followed
NMASK
ALARM
37