Advertisement
- Connecting point for parking brake signal (example) -
1
Use a splicing connector to connect the parking
brake signal wire (red/white) coming from the
main unit to the parking brake signal wire of the
vehicle.
2
Route the parking brake signal wire to the main
unit.
- Connecting point for reverse signal (example) -
Tip
• • Be sure to connect the reverse signal wire. If it is
not connected, the vehicle position may be
incorrect when the vehicle is reversed.
• • Use a circuit tester to confirm that a sensing
voltage of 6 V or higher is generated when the
vehicle is reversed.
1
Use a splicing connector to connect the reverse
signal wire (green) coming from the main unit to
the reverse signal wire of the vehicle.
2
Route the reverse signal wire to the main unit .
- Using the splicing connector -
1
Insert the interconnecting wire [vehicle speed
pulse signal wire (purple/white), parking brake
signal wire (red/white), or reverse signal wire
(green)] from the main unit and the vehicle wire
into the splicing connector.
2
Push in the terminal (the metal part) of the
splicing connector using a pair of pliers.
3
Press down the cover of the splicing connector
and squeeze it until it locks.
Attach a splicing
connector at this location.
Parking brake
signal wire
Attach a splicing
connector at this location.
Reverse signal wire
Harness in the car
Splicing connector
10
- 11 -
Hand-operated
parking brake
Parking brake
signal Wire
Foot-operated
parking brake
Reverse lamp
Reverse signal wire
Vehicle speed pulse signal wire
(purple/white), parking brake wire,
(red/white) or reverse wire (green)
Lock
Splicing connector
10
Advertisement
