Advertisement
4
iCAM4000 Installation
1. Remove the two security screws (use included security bit wrench) from the bottom of the iCAM
2. While gently pulling the cover upward on the back plate, pull forward.
3. Position the iCAM back plate on the desired wall near the secured door and mark the holes as the figure below
illustrates. The recommended height from the floor to bottom of unit is 142cm (56"), however the installation
height can be adjusted depending on average user height.
HOLE
HOLE
HOLE
Dimensions and Screw Holes on the Rear Enclosure
68.5
25
Rotation Part with Front Enclosure
Dimensions of iCAM4000 (mm unit)
210
206.4
181.6
HOLE
HOLE
HOLE
Wall
43.5
8
42.9
Rear Enclosure
HOLE
Advertisement
