Miele DA 424 V EXT Operating And Installation Instructions
  1. Manuals
  2. Brands
  3. Miele Manuals
  4. Ventilation Hood
  5. DA 424 V EXT
  6. Operating and installation instructions
Miele DA 424 V EXT Operating And Installation Instructions

Miele DA 424 V EXT Operating And Installation Instructions

Cooker hoods
Hide thumbs Also See for DA 424 V EXT:
Table of Contents

Advertisement

Quick Links

See also: Operation & Installation Manual
Operating and installation instructions
Cooker hoods
DA 420 V, DA 420 V EXT
DA 424 V, DA 424 V EXT
GWOZHr
To avoid the risk of accidents
or damage to the appliance
it is essential to read these
instructions before it is installed
or used for the first time.
M.-Nr. 06 740 240

Advertisement

Table of Contents
loading

Related Manuals for Miele DA 424 V EXT

Summary of Contents for Miele DA 424 V EXT

  • Page 1 Operating and installation instructions Cooker hoods DA 420 V, DA 420 V EXT DA 424 V, DA 424 V EXT GWOZHr To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed or used for the first time.

  • Page 2: Table Of Contents

    Contents Caring for the environment ......... . 3 Warning and Safety instructions .

  • Page 3: Caring For The Environment

    Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment.

  • Page 4: Warning And Safety Instructions

    Warning and Safety instructions Technical safety This appliance complies with all Before connecting the appliance to relevant local and national safety the mains supply, make sure that requirements. Inappropriate use the voltage and frequency details given can, however, lead to personal injury on the data plate correspond with the and damage to property.
  • Page 5 Overheated oil and fat can These models may only be combined ignite and could set the cooker hood on with a Miele external motor. fire. In countries where there are areas Do not use the cooker hood without which may be subject to infestation the grease filters in place.
  • Page 6 All ducting, pipework and fittings Installation must be of non-flammable material. Safety regulations prohibit the These can be obtained from the Miele fitting of a cooker hood over solid Spare Parts department or from fuel stoves. builders’ merchants. The appliance must not be connected to a chimney or vent flue which is in use.
  • Page 7 Warning and Safety instructions Using at the same time as other In order to ensure safe operation, and heating appliances that depend on to prevent gases given off by the heating appliances from being drawn the air from the room back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the...
  • Page 8 The Miele control module DSM 400 offers the possibility of combining such components with the cooker hood (see "Operation with a control module").

  • Page 9: Modes Of Operation

    Modes of operation . . . air recirculation: The cooker hood works with (Applies to the DA 420 V only. A conversion kit and charcoal filter are required, which are available as . . . air extraction: optional accessories: see "Technical Data") The air is drawn in, cleaned by the grease filters and directed outside.

  • Page 10: Guide To The Appliance

    Guide to the appliance...
  • Page 11 Guide to the appliance a Cover plate m Touch control for the grease filters b Telescopic tower The indicator lamp for the grease filter touch control lights up when the grease c Canopy filters need to be cleaned. The canopy is not designed to be This control is used to reset the used as a shelf.

  • Page 12: Use

    To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off touch control. ^ To set this option, both the fan and The fan runs at power level "II".

  • Page 13: Run-On Option

    Run-on option It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction I and IV will flash if the automatic or recirculation mode.

  • Page 14: To Switch The Lighting On

    To switch the lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting touch control ^ Pressing the On/Off touch control will to switch on the hob lighting.

  • Page 15: Filter Operating Hours Counter

    Filter operating hours counter Reading the filter operating hours counter The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The indicator lamp for the grease filter ^ Press the On/Off touch control to touch control will come on after 30 switch the fan on.
  • Page 16 Filter operating hours counter You can set the operating hours counter to suit the type of cooking you The – /+ control lamps show the time – Select a short time if you roast or fry which has been set: a lot.
  • Page 17 ^ Use the – /+ touch controls to select Setting and altering the charcoal filter operating hours counter the desired time. (with recirculation mode) The charcoal filter is needed for recirculation mode. ^ Confirm the selection by pressing the The cooker hood is set at the factory for extraction mode.

  • Page 18: Adjusting The Height Of The Canopy

    Adjusting the height of the canopy The height adjustment feature on the canopy can be used to – – adapt the height of the hood to suit the installation conditions. – adjust the working area underneath the hood to the height of the user. –...

  • Page 19: Cleaning And Care

    (This infomation does not apply to the controls). General notes Stainless steel surfaces can be cleaned The surfaces and controls are using the Miele E-cloth, or with a susceptible to scratches and proprietary non-abrasive cleaning abrasions. Please observe the agent designed specifically for use on following cleaning instructions.

  • Page 20: Grease Filters

    Cleaning and care Controls The controls may suffer discolouration or damage if soiling is left on them for too long. Remove soiling straight away. Observe the General notes on cleaning earlier in this section. Do not use stainless steel cleaning agents on the controls.

  • Page 21: Fitting And Replacing The Charcoal Filter

    New filters can be purchased from are facing down towards the hob. your Miele dealer or from the Miele Spare Parts Department. See back cover for contact details, and "Technical data" for the model number of the filter.
  • Page 22 Cleaning and care Always replace the charcoal filter imme- diately if – the indicator lamp for the charcoal filter touch control lights up, – if it is no longer effective in absorbing kitchen odours. It should, however, be replaced at least every 6 months.

  • Page 23: Changing A Halogen Lamp

    Cleaning and care Changing a halogen lamp Before any cleaning or maintenance work, the cooker hood must be disconnected from the mains supply. Ensure that, depending on connection: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug is removed, or –...

  • Page 24: Appliance Dimensions

    Appliance dimensions 1) Alternative positions for feeding through the mains cable 2) For EXT appliances: Cut-out for feeding the connection cable through to an external motor, min. 65 x 30 mm 3) Height range for appliance in extraction mode 4) Height range for appliance in recirculation mode 5) Ventilation grille positioned at the top for recirculation...

  • Page 25: Safety Distance Between Hob And Cooker Hood (S)

    Appliance dimensions Safety distance between hob and cooker hood (S) The minimum safety distances between the top of a cooker or hob and the bottom of the cooker hood are as follows, unless a greater distance is specified by the manufacturer of your cooking appliance: –...

  • Page 26: Installation

    Installation Assembly parts Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the "Warning and Safety instructions" at 4 screws 8 x 60 mm with the beginning of this booklet. 4 washers and This is particularly crucial when 4 plugs S 10 to secure the cover plate...

  • Page 27: Electrical Connection

    Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to install and local safety regulations a residual current device (RCD) with a...

  • Page 28: Operation With Control Module Dsm 400

    Operation with Control module DSM 400 The Miele DSM 400 Control module can If the control module is be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window It enables the following: contact switch (e.g.

  • Page 29: Connection To A Light Switch

    Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it via a light switch in the house. Installation The control module is fitted in the tower after the cover plate has been unscrewed from the ceiling.

  • Page 30: Connection For Air Extraction

    Connection for air extraction – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as...

  • Page 31: Condensate Trap

    Connection for air extraction Important: Cooker hoods designated for use with an external motor (...EXT models), have If the exhaust ducting is to run through an integrated condensate trap. rooms, ceiling space etc. where there may be great variations in temperature Silencer between the different areas, the problem of condensation will need to...

  • Page 32: After Sales Service

    In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.

  • Page 33: Technical Data

    DA 424 V....47 kg DA 424 V EXT ....43.8 kg...
  • Page 36 Alteration rights reserved / 1006 M.-Nr. 06 740 240 / 01 en - GB...

This manual is also suitable for:

Da 420 v ext

Table of Contents