05-4055A01, Rev. E
Figure 3-51. Reprogramming Menu
•
TFTP Host Address
to get the file. [
•
Firmware Filename
server. Verify that this string corresponds to the TFTP directory
location. May require a sub-directory (for
example:
entranet/bkrfto-1_0_0.gpk)
[
Any 40-character alphanumeric string
•
—Time in seconds the TFTP server waits for a
TFTP Timeout
packet ACK (acknowledgment) from the transceiver before
suspending the file transfer. [
•
—Initiate the file transfer from the TFTP server.
Retrieve File
Placed into inactive firmware position in the transceiver's
non-volatile memory. [
•
—Verify the integrity of the firmware file held in the
Image Verify
radio.
•
—Initiate the copying of the active firmware into the
Image Copy
inactive image.
•
—Initiate restarting the transceiver. This interrupts
Reboot Device
data traffic through this radio and the network, if performed on
an AP. Use this command to toggle between firmware images.
•
Current Firmware
3.11.2 Configuration Scripts Menu
A Brief Description of Configuration Files
If you plan to have more than a few transceivers in your network, you
might want to use the Configuration Scripts Menu
Page
88) to configure similar radios from a common set of parameters.
Over 50 customer settings that optimize the network are saved in a
MDS entraNET Technical Manual
—IP address of the host computer from which
]
Any valid IP address
—Name of file to be received from the TFTP
.
]
10 to 120 sec; 30
]
Y, N
—Shows the current firmware revision level.
]
(Figure 3-52 on
87