Panasonic LUMIX DMC-FX520 Operating Instructions Manual page 34

[FORMAT]
•
Use a battery with sufficient battery power or the AC adaptor (optional) when formatting. Do not
turn the camera off during formatting.
•
If a card has been inserted, only the card is formatted. To format the built-in memory, remove
the card.
•
If the card has been formatted on a PC or other equipment, format it on the camera again.
•
It may take longer to format the built-in memory than the card.
[CALIBRATION]
Calibration is not done if correct position is not touched. Touch the [ i ] mark again.
•
~ [LANGUAGE]
•
If you set a different language by mistake, select [~] from the menu icons to set the desired
language.
[DEMO MODE]
DEMO
A Jitter detection demonstration
B Movement detection demonstration
•
In playback mode, [JITTER, SUBJ. MOVE DEMO.] cannot be
displayed.
•
Press [DISPLAY] to close [JITTER, SUBJ. MOVE DEMO.].
Press [MENU/SET] to close [AUTO DEMO].
•
[JITTER, SUBJ. MOVE DEMO.] is an approximation.
•
[AUTO DEMO] has no TV output capability.
Preparation
The built-in memory or card is formatted. Formatting
irretrievably deletes all the data so check the data carefully
before formatting.
Adjust the position of the touch panel if a different thing gets
selected from what you touched or touch operation does not
respond.
1
Press [MENU/SET].
2
Touch the orange [r] mark
displayed on the screen in
order with the stylus pen
(supplied) (5 places).
•
A message is displayed once the
position is set.
3
Press [MENU/SET] to finish.
Set the language displayed on the screen.
Select this to display [JITTER, SUBJ. MOVE DEMO.] or the
camera's features.
[JITTER, SUBJ. MOVE DEMO.]
[AUTO DEMO]:
- 34 -
The camera's features are displayed as a slide
show.
A
B