Signal Menu; Y/C Filter - For Ntsc Av Images - Panasonic TH-42PH20E Operating Instructions Manual

Signal menu

Note:
"Signal" setup menu displays a different setting condition for each input signal.
1
2
3
4
3D Y/C Filter
This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.
Select "Signal" from the "Setup" menu during Video (S Video) input signal. ("Signal [AV]" menu is displayed.)
Note:
When On, this setting only affects NTSC input signals.
Press to display the Setup menu.
Press to select the "Signal".
Press to display the Signal menu.
Press to select the menu to adjust.
Press to adjust the menu.
Press to exit from adjust mode.
– For NTSC AV images
Press to select the "3D Y/C Filter (NTSC)"
Press to set On / Off.
Setup for Input Signals
For Video (S VIDEO)
[ AV ]
Signal
On
3D Y/C Filter (NTSC)
Colour system Auto
Cinema reality Off
Noise reduction
Off
For Component
[ Component ]
Signal
Sync Auto
Cinema reality Off
XGA Mode Auto
Noise reduction Off
H-Freq. 63.98 kHz
V-Freq. 60.02 Hz
Signal Format 1280×1024/60
Setup
Signal
Screensaver
Extended life settings
Input label
Component/RGB-in select
RGB
Power save
Off
Standby save Off
PC Power management Off
Off
DVI-D Power management
Off
Auto power off
Off
English ( UK )
OSD Language
Press ACTION ( ) button
For RGB
Signal
Sync Auto
Cinema reality
XGA Mode Auto
Noise reduction
H-Freq. 63.98 kHz
V-Freq. 60.02 Hz
Signal Format 1280×1024/60
For Digital
Signal
Cinema reality
Noise reduction
H-Freq. 63.98 kHz
V-Freq. 60.02 Hz
Dot Clock Freq. 108.0 MHz
Signal Format 1280×1024/60
3D Y/C Filter (NTSC) On
1/2
[ RGB ]
Off
Off
[ Digital ]
Off
Off
39