TCD210G(e-g).book Page 45 Friday, January 14, 2005 1:42 PM
Problem
While viewing caller information, the
display returns to standby mode.
I cannot register a handset to a base
unit.
SMS (Short Message Service)
Problem
I cannot send or receive SMS
messages.
"FD" is displayed.
"FE" is displayed.
"E0" is displayed.
"Q" is not displayed after you read a
message. An error code ("FD", "FE",
or "E0") is displayed.
"Allgemein" and "Private
Mailbox" are not displayed.
Cause & solution
L Do not pause for over 1 minute while searching.
L The maximum number of base units (4) are already
registered to the handset. Cancel unused base unit
registrations from the handset (Seite 37).
L The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (Seite 37).
L You entered the wrong PIN number. If you forget your
PIN, consult your nearest Panasonic service centre.
L Locate the handset and the base unit away from other
electrical appliances.
Cause & solution
L You have not subscribed to the appropriate service.
Consult your service provider.
L The SMS message centre number(s) are not stored or
are incorrect. Store the correct numbers (Seite 29).
L Message transmission was interrupted. Wait until the
message has been sent before using other telephone
functions.
L SMS message memory is full. Erase unnecessary
message in the receive and send lists (Seite 31, 32).
L The unit could not connect to the SMS message centre.
Confirm that the correct SMS message centre numbers
are stored (Seite 29). Confirm that SMS is turned on
(Seite 29).
L An error occurred while sending the message. Try again.
L Your phone number is permanently withheld or you have
not subscribed to the appropriate service. Consult your
service provider.
L When an error code is displayed, "Q" will not be
displayed even if you have read the message.
L You selected "Österreich" as the country when
resetting the base unit. Reset the base unit again and
select "Deutschland" (Seite 26).
Useful Information
45