Installation
1.
Select a good location.
Place your freezer where it is easy to use.
2.
Avoid placing the unit near heat sources, direct
sunlight or moisture.
3.
To avoid vibration, the unit must be leveled.
If required, adjust the leveling screws to
compensate for the uneven floor.
The front should be slightly higher than the rear
to aid in door closing.
Leveling screws can be turned easily by tipping
the cabinet slightly.
Turn the leveling screws counterclockwise (
to raise the unit, clockwise (
4.
Clean your freezer thoroughly and wipe off all
dust accumulated during shipping.
5.
Install accessories such as ice cube box, etc., in
their proper places. They are packed together to
prevent possible damage during shipment.
6.
Connect the power supply cord (or plug) to the
outlet. Don't double up with other appliances
on the same outlet.
7.
Product with handle
shall be located at least
55 mm from the wall
on the hinge side to
open door by 90°
8.
The warm air under bottom and rear side of the
product have to release.
Otherwise, This will
increase the power
consumption.
Starting
When your freezer is installed, allow it 2-3 hours to
stabilize at normal operating temperature prior to
filling it with fresh or frozen foods.
If power plug is disconnected, allow 5 minutes
delay before restarting.
Your freezer is now ready for use.
)
) to lower it.
at least
50 mm
100 mm
50 mm
11
Climate class
The appliance is designed to operate at the limited
range of ambient temperature, depending on
climate zones. Do not use the appliance at the
temperature out of the limit. Climate class of your
appliance is indicated on the label with technical
description inside the fridge compartment.
Class
Symbol
Extended
SN
temperate
Temperate
N
Subtropical
ST
Tropical
T
Extended
temperate
SN-T
-Tropical
Installation
Ambient temperature
range °C
+10 ~ +32
+16 ~ +32
+16 ~ +38
+16 ~ +43
+10 ~ +43