Table Of Contents - GE ZDBI240WCII Installation Instructions Manual

Safet Information
BEFORE YOU BEGIN:
Read these instructions completelg and carefullg.
IM PORTANT - Save these instructions
for local inspector's use.
IM PORTANT -Observe all
g overning
codes
and ordinances.
Note to Installer - Be sure to leave these
instructions with the Consumer.
Note to Consumer - Keep
these instructions with
your Owner's Hanual for future reference.
_WARNING
- This appliance must
be properly grounded. See page 5.
_AVERTISSEMENT -
Cet appareil doit _tre correctement mis 5 la terre.
Consultez page 5.
If you received a damaged wine chiller, wine reserve
or beverage center, you should immediately contact
your dealer or builder.
Skill Level
-Installation requires basic mechanical
skills. Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty.
_WARNINGS:
• Use this appliance only for its intended purpose.
• Immediately repair or replace electrical service cords
that become frayed or damaged.
Unplug the unit before cleaning or making repairs.
Repairs should be made by a qualified service
technician.
_k AVERTISSEMENT :
• II ne faut utiliser cet appareil que pour I'usage pour
lequel il a _t_ construit.
II faut r_parer ou remplacer imm_diatement tout
cordon d'alimentation _lectrique effiloch_ ou
endommag_.
D_brancher le bar ou le r_frig@ateur a vin avant
le nettoyage ou toute intervention.
Les r_parations doivent _tre faites par un technicien
qualifi_.
For Monogram local service in gour area, call
1.800.444.1845
For Monogram service in Canada, call
1.800.561.3344
For Monogram Parts and Accessories, call
1.800.626.2002.
www.monogram.com
CONTENTS
Design Guide
The Instollotion Spoce.............................. 3
Side-by-Side Instollotions ..................... 4
Product Clearances ................................... /4
Installation Instructions
Tools Required .............................................. 5
Grounding the Product ........................... 5
Staining Wood Drawer Fronts ............. 5
Installing the Custom Frame Panel ...5
Step 1, Remove Packaging .................... 5
Step 2, Reverse Door Swing ................... 6
Step 5, Level .................................................. 7
Step/4, Connect Power ............................. 7
Step 5, Slide Product into Cutout ......... 7
Step 6, Install Nameplate ........................ 7
Step 7, Set Temperature Controls ....... 7
Custom Frame Panel Hodels ................ 7
Template for Nameplate.... Back Cover