Injection pressure(MPa) 0.02~0.2 Specifications may be subject to change without prior notice 50Hz USER WASHING MACHINE SEMI AUTO WASHING MACHINE HWM108VA Manual CONTENTS Packing list Names of the parts Safety precautions Installation and adjustment Preparation before washing Do s and don ts...
× ° Ï ä Ë µ Ã ÷ Packing list Quantity Name One piece User's manual One piece Warranty card One piece Water inlet hose Gland Semi Auto washing machine One piece One set...
Trouble-shooting Answers to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company.
× ¢ Ò â Ê Â Ï î Safety precautions Please insert the power cord into When the machine is normally special receptacle with rated vol- using, please put the power plug tage.Be sure to use single-phase at the location easily to be insert- three pins receptacle.The earthing ed and extracted by hand.
Page 5
Disposal of the complete unit Wipe the complete unit with soft cloth twisted dry. Wipe with neutral detergent if too dirty. Do not wash it directly by water. After washing, dismount the water inlet hose. Do not store water in the tub for long period. Discharge the water immediately after each using.
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause...
Maintenance Ï ´ º ó ´ ¦ À í After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Cleaning the lint filter The lint filter must be used during washing.
Preparation before washing Ï ´ Ç ° × ¼ ± ¸ Preparation before washing 1.Connect the water inlet hose. 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.
Rinsing Rinse with water-filling 1.Put the laundries Put the laundries into the wash tub. Select suitable current according to the laundries. 2.Adjust the water level Set the water level with water level adjusting lever according to the laundries quantity. Then fill suitable water continuously. 3.Rinse Adjust the wash timer to 5-7 minutes to do rinsing.
Ï ´ µ Ó Ë ³ Ð ò Washing sequence Drain selector Wash selector Wash timer Not set the switch to (Strong current, DRAIN during washing (To set to below 2 minutes, Standard current) first set to 6 minutes then turn it back.).