Page 2
... any technical problems or other questions you need clarified? Please contact: • your sales partner • your sales outlet The latest information and updates (e. g. BIOS update) on our mainboards can be found on the Internet under: http://www.fujitsu-siemens.com...
Page 4
Questo manuale è stato stampato su carta da riciclaggio. Denna handbok är tryckt på recyclingpapper. Dit handboek werd op recycling-papier gedrukt. Herausgegeben von/Published by Fujitsu Siemens Computers GmbH A26361-D1692-Z120-1-7619 Bestell-Nr./Order No.: Printed in the Federal Republic of Germany AG 1103...
Page 5
English Mainboard D1692 Technical Manual November 2003 edition...
Page 7
All other trademarks referenced are trademarks or registered trademarks of their respective owners, whose protected rights are acknowledged. Copyright Fujitsu Siemens Computers GmbH 2003 All rights, including rights of translation, reproduction by printing, copying or similar methods, even of parts are reserved.
Mainboard D1692 Your mainboard is available in different configuration levels. Depending on the configuration chosen, some of the hardware components described may not be available on your mainboard. Notational conventions The meanings of the symbols and fonts used in this manual are as follows: indicates information which is important for your health or for preventing physical damage.
Mainboard D1692 Important notes With the mainboard installed you must open the system to access the mainboard. How to dismantle and reassemble the system is described in the operating manual accompanying the system. Connecting cables for peripherals must be adequately shielded to avoid interference.
Mainboard D1692 List of features Processor • Dual µPGA 940-pin ZIF sockets • ™ Supports up to two AMD Opteron processors • Two onboard 3-phase VRMs • 128-bit DDR dual-channel memory controller integrated in CPU Chipset • ™ AMD-8131 PCI-X Tunnel •...
Page 14
Mainboard D1692 Integrated Audio • AMD-8111 AC97 Audio Controller • Analog Devices AD1981b Audio Codec • One RCA SPDIF digital connector • Line-in, line-out (headphone capable), mic-in, rear connectors • Line out (headphone capable) & MIC front panel headers •...
Board Installation Board Installation The mainboard D1692 supports EPS12V/SSI type power supplies (24pin + 8pin + 6pin) and will not operate with any other types. For proper power supply installation procedures see "Installing the Power Supply" section DO NOT USE ATX 2.x, ATX12V or ATXGES power supplies as they will damage the board and void your warranty.
This diagram is representative of the latest board revision available at the time of publishing. The board you receive may not look exactly like the above diagram. Jumper Legend OPEN - Jumper OFF without jumper cover CLOSED - Jumper ON with jumper cover Key Pin Missing pin to indicate proper orientation A26361-D1692-Z120-1-7619...
Close this jumper if the card you are using does not support PCI-X COM2 Header (J42) COM2 Header Use these pin definitions to connect a port to COM2 "" "" "" Signal Signal "" Data Carrier Detect Data-Set-Ready "! Receive-Data Request-to-Send Transfer-Data Clear-to-Send Data Terminal Ready Ring-Indicator Ground NC/KEY A26361-D1692-Z120-1-7619...
MIC BIAS Audio Analog Right Front out Right Rear In No Connect Left Front Out Left Rear In WARNING: Do not place jumpers on this header in any other configuration. Doing so could result in damage to the motherboard! A26361-D1692-Z120-1-7619...
FAN3: Max 3.0 Amp Rear fan. Controlled and monitored FAN6: Max 2.0 Amp Front fan. Controlled and monitored FAN4: Max 2.0 Amp AUX fan. This fan header is not controlled or monitored FAN5: This fan header is not controlled or monitored A26361-D1692-Z120-1-7619...
CPU0 memory banks are addressable. There must be used identical processors for CPU0 and CPU1. Fujitsu Siemens Computers is not liable for damage as a result of operating an unsupported configuration. The diagram is provided as a visual guide to help you install socket processors and may not be an exact representation of the processors you have.
The diagram illustrates how to connect fans onto the motherboard. Installing the Memory Before attempting to install any memory, make sure that the memory you have is compatible with the motherboard as well as the processor. The following diagram shows common types of DDR SDRAM modules: A26361-D1692-Z120-1-7619...
Page 27
Add-on modules / Upgrading Here are a few key points to note before installing memory into your mainboard D1692. • Always install memory beginning with CPU0/DIMMA1 and CPU0/DIMMA2. • In order to access memory on CPU1; both processors must be installed.
Attaching the IDE drive cable is simple. These cables are “keyed” to only allow them to be connected in the correct manner. The mainboard D1692 has two on-board IDE channels, each supporting two drives. The black connector designates the Primary channel, while the white connector designates the Secondary channel.
The maximum supported length of an IDE cable is 18”. • There are no Master/Slave jumpers on SATA drives. The mainboard D1692 is also equipped with four Serial ATA (SATA) channels. The following pictures illustrate how to connect an SATA drive. 1 = SATA drive cable connection...
Simply find the appropriate slot for your add-in card and insert the card firmly. Never force any add-in cards into any slots if they do not seat in place. Doing so will damage the motherboard and void your warranty. *The AGP slot supports AGPPRO & 1.5v(4x/8x) AGP cards only A26361-D1692-Z120-1-7619...
Connecting external devices to the motherboard is an easy task. The standard devices you should expect to plug into the motherboard are keyboards, mice, and printer cables. The following diagram will detail the ATX port stack for the mainboard D1692: A26361-D1692-Z120-1-7619...
Installing the Power Supply There are three power connectors on your mainboard D1692. The mainboard D1692 requires an EPS12V (24-pin + 8-pin) power supply to boot. You also have an option of using an SSI V3.0 spec. Workstation power supply. This is only necessary when an AGP PRO110W card is used.
Press the locking lug in the direction of the arrow; the battery jumps somewhat out of the Ê holder (1). Remove the battery (2). Ê Insert a new lithium battery of the same type into the socket (3). Ê A26361-D1692-Z120-1-7619...
Add-on modules / Upgrading BIOS update When should a BIOS update be carried out? Fujitsu Siemens Computers makes new BIOS versions available to ensure compatibility to new operating systems, new software or new hardware. In addition, new BIOS functions can also be integrated.
Firmware Hub Universal Serial Bus GMCH Graphics and Memory Controller Video Graphic Adapter Graphics Performance Wake On LAN Accelerator Inter Integrated Circuit IAPC Instantly Available Power Managed Desktop PC Design I/O Controller Hub Intelligent Drive Electronics IPSEC Internet Protocol Security A26361-D1692-Z120-1-7619...