Table of Contents
Related Manuals for Miele F 9122 Ui-1
Summary of Contents for Miele F 9122 Ui-1
- Page 1 Operating and installation instructions Freezer F 9122 Ui-1 en - GB To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 09 265 210...
-
Page 2: Table Of Contents
Contents Guide to the appliance ..........4 Caring for the environment . - Page 3 Contents Installation ............31 Side-by-side installation.
-
Page 4: Guide To The Appliance
Guide to the appliance a On/Off button d Super freeze button and indicator light b Temperature selector button e Alarm off button and c Temperature display indicator light f Freezer drawers g Ventilation gaps... -
Page 5: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. -
Page 6: Warning And Safety Instructions
Any other usage is not supported by This appliance complies with all the manufacturer and could be relevant safety requirements. dangerous. Miele cannot be held liable Improper use can, however, present for damage resulting from incorrect or a risk of both personal injury and improper use or operation of the material damage. -
Page 7: Technical Safety
Warning and Safety instructions Technical safety - disconnect from the mains, - air the room in which the appliance is Before setting up the appliance, located for several minutes and check it for any externally visible - contact the Service Department for damage. - Page 8 Faulty components must only be observed and regularly tested and replaced by genuine Miele original where there is any doubt, the spare parts. The manufacturer can only household wiring system should be guarantee the safety of the appliance inspected by a qualified electrician.
- Page 9 Warning and Safety instructions Correct use Do not store cans or bottles containing carbonated drinks or liquids Never handle frozen food with wet which could freeze in the freezer. The hands. Your hands may freeze to the cans or bottles could explode. frozen food.
-
Page 10: Disposal Of Your Old Appliance
Warning and Safety instructions Disposal of your old appliance Never place electric heaters or candles in the appliance to defrost it. Before disposing of an old These can damage the plastic parts. appliance, first make the door latch or Do not use defrosting sprays or lock unusable. -
Page 11: How To Save Energy
How to save energy Normal energy Increased energy consumption consumption Installation site In a ventilated room. In an enclosed, unventilated room. Protected from direct sunlight. In direct sunlight. Not near to a heat source (radiator, Near to a heat source (radiator, oven). -
Page 12: Switching On And Off
Switching on and off Before using for the first time Switching off ^ Press the On/Off button until the Cleaning temperature display goes out. ^ Clean the inside of the appliance and All the displays will go out and the the accessories with lukewarm water cooling system will switch off. -
Page 13: The Correct Temperature
The correct temperature Setting the temperature It is very important to set the correct temperature for storing food in the appliance. Micro-organisms will cause food which is not stored at the correct temperature to deteriorate rapidly. Temperature influences the growth rate ^ Press the temperature button of these micro-organisms. -
Page 14: Temperature Display
The correct temperature Temperature display The temperature display on the control panel always shows the required temperature. The temperature can be adjusted from: -15 °C to -32 °C The temperature display will flash if – the temperature in the appliance is not within the possible temperature range, –... -
Page 15: Alarm
Alarm Switching the alarm off early Your appliance has been fitted with a warning system which ensures that the If the noise disturbs you, you can temperature in the freezer cannot rise switch the alarm off early if you wish. unnoticed and to avoid energy being wasted if the door is left open. -
Page 16: Super Freeze
Super freeze Switch the Super freeze function on Switching off Super freeze before putting fresh food into the The Super freeze function will switch off freezer. automatically after approx. 65 hours. This helps food to freeze quickly and The indicator light will go out and the retain its nutrients, vitamins, flavours appliance will run at normal power and appearance. -
Page 17: Freezing And Storing Food
Freezing and storing food Maximum freezing capacity Storing frozen food To ensure that fresh food placed in the When buying frozen food to store in freezer freezes through to the core as your freezer, check quickly as possible, the maximum –... -
Page 18: Home Freezing
Freezing and storing food Home freezing lightly before freezing, but care should be taken as the taste of some Only freeze fresh food which is in a spices alters when frozen. good condition. – Do not place hot food or drinks in the Hints on home freezing freezer. -
Page 19: Before Placing Food In The Freezer
Freezing and storing food Before placing food in the freezer – Freezing the maximum amount (see data plate) ^ When freezing more than 2 kg of ^ Remove the lower freezer drawers. fresh food, switch on the Super freeze function some time before ^ Place the food flat on the bottom of placing the food in the freezer (see the appliance or in contact with the... -
Page 20: Defrosting
Freezing and storing food Defrosting Never re-freeze partially or fully Frozen food can be defrosted in defrosted food. Consume defrosted different ways: food as soon as possible as it will lose its nutritional value and spoil if – in a microwave oven, left for too long. -
Page 21: Defrosting
Defrosting In normal use, ice and frost will form in Do not scrape off ice and frost and the freezer section, e.g. on the internal do not not use any sharp edged or walls. How much ice and frost accumulates in the appliance will pointed instruments to aid the defrosting process. - Page 22 Defrosting To defrost After defrosting ^ Clean the appliance and then dry it Carry out the defrosting procedure thoroughly. as quickly as possible if food has ^ Close the appliance door. not been placed in another freezer. The longer the food is left out at ^ Reconnect to the mains and switch room temperature, the faster it the appliance back on.
-
Page 23: Cleaning And Care
Cleaning and care Before cleaning Make sure that water cannot get into ^ Switch the appliance off. the electronic unit or into the ^ Disconnect the appliance from the ventilation gaps. mains. Do not use steam cleaning ^ Take any frozen food out of the apparatus to clean the appliance. -
Page 24: Ventilation Gaps
Cleaning and care Ventilation gaps ^ The ventilation gaps should be cleaned regularly with a brush or vacuum cleaner. A build-up of dust will increase the energy consumption of the appliance. Door seal Do not use any oils or grease on the door seal as these will cause the seal to deteriorate and become porous over time. -
Page 25: Problem Solving Guide
Contact a qualified electrician or the ^ Check that the door has been closed Miele Service department. properly. ^ Check to see whether a thick layer of . . . the appliance does not get cool ice has built up in the freezer. If it... - Page 26 . . . the Super freeze indicator light and the temperature display are both flashing at the same time. ^ There is a fault. Call Miele Service.
-
Page 27: Noises
Noises Normal noises What causes them Humming noise made by the motor (compressor). This noise can Brrrrr... get louder for brief periods when the motor is switching on. Blubb, blubb..A gurgling noise can be heard when coolant is circulating through the pipes. -
Page 28: After Sales / Guarantee
– your Miele Dealer – Miele (see back cover for contact details). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. This information is given on the data plate inside your appliance. -
Page 29: Information For Dealers
Information for dealers Demo mode To deactivate Demo mode ^ Press the On/Off button. The appliance can be demonstrated in the showroom or at exhibitions in The appliance is now switched on. "Demo mode". In this mode the controls ^ Press the On/Off button and the and interior lighting are functioning but Temperature button at the same time the compressor remains switched off. -
Page 30: Electrical Connection
Electrical connection Electrical connection U.K. Non-rewireable plugs (BS 1363) All electrical work should be carried out The fuse cover must be re-fitted when by a suitably qualified and competent changing the fuse, and if the fuse cover person in strict accordance with current is lost, the plug must not be used until a local and national safety regulations suitable replacement is obtained. -
Page 31: Installation
Installation Location This appliance must be built in, This appliance should be installed in a otherwise it could tip up. dry, well-ventilated room. It should not be installed where it is exposed to Side-by-side installation direct sunlight or directly adjacent to a heat-producing appliance such as an The left side of this appliance has side oven or a radiator. -
Page 32: Ventilation
Installation Ventilation Before installing the appliance ^ Remove any cable clips from the Air at the back of the appliance gets warm. It is very important for the back of the appliance. cooling system of the appliance to have adequate ventilation. Ventilation into and out of the appliance is through the appliance plinth. -
Page 33: Building-In Dimensions
Building-in dimensions Plinth height B depends on the building under height: With a niche height of 820 mm the plinth height is 100 - 170 mm. The plinth height will be dictated by the height of the furniture front. With a building under height of 870 mm the plinth height is 150 - 220 mm. -
Page 34: Adjusting The Door Hinges
Adjusting the door hinges The door hinges are set ex-works to enable the doors to be opened wide. However, if the opening angle of the door needs to be limited for any reason, the hinges can be adjusted to accommodate this. For example, if the appliance door hits an adjacent wall when opened, the opening angle can be limited to 90°. -
Page 35: Changing The Door Hinging
Changing the door hinging Appliance door Do not change the door hinging if ^ Open the door. this appliance is to be installed "side-by-side" with another appliance. Each appliance must be built-under into a separate niche and the freezer must be installed on the right-hand side of the refrigerator. - Page 36 Changing the door hinging ^ Stand the appliance door up, and If you have put locking pins into the hinges to stop the door opening too far: loosen the hinges at the front (the hinges remain open). ^ Remove the locking pins from the top of the hinges.
- Page 37 Changing the door hinging To secure the soft-close mechanism ^ Place the door with the outer side downwards on a stable surface. ^ Refit the door onto the pre-fitted ^ Screw ball joint d of soft-close screws, and then tighten the screws. mechanism c into the new fixing ^ Replace covers a, b and c.
-
Page 38: Building In The Appliance
Appliance Maximum weight of – a hexagon spanner, furniture door in kg – an allen key. F 9122 Ui-1 Positioning the appliance Fitting a door front which is heavier Before pushing the appliance into than the maximum permitted could the niche loosen the two rear feet by damage the hinges. - Page 39 Building in the appliance ^ Push the appliance into its building-under niche. ^ Align the appliance so that the front edges of the hinges at the top and bottom are flush with the front edge of the housing unit side wall. This will create a gap all round of 42 mm to the front edges of the housing unit side walls.
-
Page 40: Aligning The Appliance
Building in the appliance Aligning the appliance ^ Hold the plinth facing at the side and pull it forwards and off. With a building-under height of 820 mm the adjustable feet must not be extended. With a building-under height of more than 820 mm the feet must be ^ Use an allen key to unscrew both extended. -
Page 41: Securing The Appliance In The Niche
A fitting kit for securing the appliance at the sides when building it under a granite worktop is available from Miele. If there is a continuous plinth in the kitchen, a ventilation gap will need to be made in the plinth for the appliance:... -
Page 42: Fitting A Furniture Door
Building in the appliance Fitting a furniture door Ensure that the plinth facing is replaced correctly. ^ A gap of 8 mm must be maintained between the appliance door and the ^ Using a screwdriver, carefully push fixing bracket. tension spring a outwards. ^ Push fitting aids a up to the height of the furniture door: the lower edge X Warning. - Page 43 Building in the appliance ^ Hang the furniture door onto ^ Using a pencil, lightly mark a line adjusting bolts a. down the centre of the inside of the furniture door. ^ Loosely attach nuts b on the ^ Hang the fixing bracket with fitting adjusting bolts.
- Page 44 Building in the appliance ^ Whilst counterholding adjusting bolts b with a screwdriver, tighten nuts a at the top of the appliance door. ^ Attach the appliance door and the furniture door using screws through fixing brackets a: – Drill holes in the furniture door (mark the position of the holes first).
- Page 45 Building in the appliance ^ Push tension spring a inwards again. ^ Screw mounting b onto the hinge ^ Place the cover in position. and tighten securely. To make sure the appliance is ^ Open out soft-close mechanism c correctly fitted: and hook it onto ball joint d.
- Page 48 Alteration rights reserved / 5111 M.-Nr. 09 265 210 / 01 F 9122 Ui-1...