Important Safety Instructions CLEANING THE LINT FILTER DRYING GUIDE LINT BUILD-UP IS A FIRE HAZARD Do not tumble dry The lint filter is located at the front of your dryer at the bottom of the door opening. “Normal” LINT FILTER “Delicates”...
Installation Instructions 3. Unclip the cover trim insert window from the panel. 4. Insert reverse label provided in accessory bag. WORKTOP NAME BADGE 5. Clip back the cover trim insert window. EXHAUST GRILLE DOOR SAFETY SWITCH 6. Place worktop onto original position, then slide to BUTTON LEGS the front.
Installation Instructions unventilated room. INLETS OUTLET COVER THE CONTROL PANEL Timer Programs Sensor Programs Delay Button On/Off Button This button switches the dryer on. At the end of the This button is a feature that permits you to start the program, press the button again to switch the dryer off.
Drying or Cooling cycle or the End. running, the drying process will continue using the new setting. Electrolux Name Badge NOTE: Airing cannot be selected when one of the Sensor programs has been selected. You can invert the name badge when you want to mount your dryer upside down on the wall.
Page 7
OPERATING SEQUENCE (continued) Refer to the table below for recommendations. Switch On The dryer will not operate unless the door safety Temperature Definition switch button is fully pressed in. Normal For drying most fabrics. For drying delicates and Delicates synthetics. It is lower heat DOOR SAFETY SWITCH for the maximum care of BUTTON...
OPERATING SEQUENCE (continued) Cooling Last Memory Setting Next time you turn your dryer on it will be ready to go as it remembers the last Program, Temperature and Option setting used. You can change the settings if you wish. function). It will sound again after about fifteen minutes. The drum is designed to rotate in each direction, clockwise The Clean Filter Reminder light will remain on.