LG ARNH963K2A2 Installation Manual page 61

Table 15: Common Function Code Descriptions for Hydro Kit Chassis 2 and Chassis 3 (Continued)
function Code
09 - Water Pump Test Run
13 - Zone Temperature Setpoint
(Heating Mode)
14 - Leaving Water Temperature
Setpoint (Heating Mode)
15 - Setting Hot Water (DHW) Tank
Water Temperature Setpoint
Once water pipe has been installed, Water Test Run Mode is performed
to check functioning of water circulation.
Assign temperature setpoint for air temperature in heating mode.
This is only available when Remote Air Temperature Sensor is
connected. Accessory PQRSTA0 should be installed. Function Code 03
must be set properly.
Assign heating setpoint temperature range when leaving temperature is
selected as setting temperature.
Assign heating setting temperature range of water tank leaving water.
This is only available when DHW tank temperature sensor is installed.
DHW tank and DHW tank kit should be installed. DIP Switch #2 and #3
should be set properly.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.
Pre-coMMIssIoNING
Function Codes - Common Settings
description
61