Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Electrolux CHDL 4150
Summary of Contents for Electrolux CHDL 4150
- Page 1 CHDL 4150 Cooker hood Operating and Installation Instructions...
- Page 2 Printed on recycled paper AEG - putting words into action...
-
Page 3: Table Of Contents
Contents Safety warnings For the User For the Installer Description of the Appliance Extractor version Filter Version Control Panel Maintenance and care Cleaning the hood Metal grease filter Removing the metal grease filter Charcoal filter Changing the light bulb What to do if Service and Spare Parts Guarantee Conditions Technical Specifications... -
Page 4: Safety Warnings
Safety warnings For the User • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. - Page 5 • It is advisable to apply for authorization from the relevant controlling authority when connecting the outlet to an unused chimney flue or combustion gas duct. The air outlet installation must comply with the regulations laid down by the relevant authorities. •...
-
Page 6: Description Of The Appliance
Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. • You will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Extractor version •... -
Page 7: Control Panel
Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. -
Page 8: Maintenance And Care
Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild deter- gent. • Never use corrosive, abrasive or flammable cleaning products. •... - Page 9 loosening cleaner, then rinse off thoroughly with hot water. Repeat the process if necessary. Refit the grease filters when they are dry. Dishwasher Place grease filters in dishwasher. Select the most powerful washing programme and highest temperature, at least 65°C. Repeat the process.
-
Page 10: Charcoal Filter
Charcoal filter • The charcoal filter should only be used if you want to use the hood in its filtering function. • To do this you will need an original AEG charcoal filter (see special accessories). • Replacing the charcoal filter The charcoal filters cannot be cleaned, we recommend that they should be replaced approximately every three months or more often if the hood is used for more than three hours per day. -
Page 11: Changing The Light Bulb
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. -
Page 12: What To Do If
What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. -
Page 13: Service And Spare Parts
Service and spare parts In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning 08705 929 929 Your call will be automatically routed to the Service Centre covering your post code area. -
Page 14: Guarantee Conditions
Guarantee conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation.The guarantee does not cover commercial use. - Page 15 Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home.They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances. France Senlis +33 (0) 3 44 62 29 29...
-
Page 16: Technical Specifications
Technical Specifications Dimensions (in cm): Height Width Depth Maximum absorbed power: 220 W Motor absorption: 140 W Lighting: 2 x 40 W (E14) Length of the cable: 150 cm Mounting accessories included 1 Flange Ø 120 mm 1 Adapter Ø 120/100 mm 4 wood-screws 2,9 x 16 Electrical connection Safety warnings for the electrician... -
Page 17: Installation
Installation - Fig. 7 • Drill the base of the wall unit to allow for passage of the hood body. Fig. 7.1. • Drill the top of the wall unit to allow for passage of the exhaust pipe and the electrical cable. Fig. 7.1. •... - Page 18 Fig. 7.1 Fig. 7...
-
Page 19: Removing The Hood From Cabinet
Removing the hood from cabinet Follow these steps: • Remove the grease filter. • Remove the 4 additional screws from the frame. • Loosen the screws on the two fixing springs. Fig. 8. Fig. 8 • Push a flat screwdriver into the hole for the fixing springs (right and left) and push each of the fixing springs inwards. - Page 20 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG LI1WYB Ed. 04/02...