Charge The Battery - Nokia RM-934 User Manual

2. If the battery is in the phone, lift it out.
3. Open the SIM holder, and slide the SIM into the holder. Close the holder, and lock it into place. Make
sure the SIM contact area is face down.
4. Line up the battery contacts, and push the battery in.
5. Insert the second SIM into the SIM2 slot with the contact area face down. Push the SIM in until it
locks into place.
Tip: To remove the SIM, push the card in until it's released, then pull it out.
6. Insert the memory card into the memory card slot. Push the memory card in until it locks into place.
Tip: To remove the memory card, push it in until it's released, then pull it out.
Important: Do not remove the memory card when an app is using it. Doing so may damage the
memory card and the device and corrupt data stored on the card.
7. Replace the back cover.
8. To switch your phone on, press and hold the power key until the phone vibrates.
Note: Switch the device off and disconnect the charger and any other device before removing
any covers. Avoid touching electronic components while changing any covers. Always store and
use the device with any covers attached.

Charge the battery

Your battery has been partially charged at the factory, but you may need to recharge it before you
can use your phone.
1. Plug the charger into a wall outlet.
© 2013 Nokia. All rights reserved.
6