MB86R02 'Jade-D' Hardware Manual V1.64
18.6.9 Parallel Dual Display
MB86R02 'Jade-D' incorporates two independent display controllers that operate in parallel.
MB86R02
display
controller 0
display
controller 1
If only using one output, se the display enable flag in DCM0/1 register to zero for the unsed display
controller. The two display controllers work independently, therefore different resolutions can be used
by each controller and therefore each works asynchronously to the other.
interrupt
VSYNC0
interrupt
VSYNC1
The phase difference indicated above of each frame should be taken into consideration when drawing
figures synchronously on two screens.
This assumes that the controllers have the same timing parameters and share the same clock source
such as the internal PLL.
If the 'display enable' flags of the controllers are activated sequentially, then the phase difference of
VSYNC will remain very small and stays constant.
Note:
Dual Display functionality is not possible with RSDS panels.
18-30
display
screen"0"
device"0"
display
screen"1"
device"1"