Parts Provided - GE JV935 Owner's Manual And Installation Instructions

PARTS PROVIDED

Locate the hardware accessory box packed with the
hood and check contents.
2 Aluminum
Grease Filters
DUCT COVER REQUIREMENTS
We recommend that the vent hood and decorative
duct cover (if used) be on site before final framing and
wall finishing. This will help to accurately locate studs,
ductwork and electrical service. Read these instructions
to determine if the duct cover accessory can be used for
your installation situation.
Duct Cover Accessory:
• Use the decorative duct
cover to conceal ductwork
running from the top of
the hood to the ceiling.
• The duct cover accessory
consists of 2 pieces. The
outside piece is 12" high,
the inside piece is 22".
Nested together they are
24" min., expanding to
a total maximum height
of 34".
• The outside piece can
be used alone to fill a
12" height.
• For heights over 12", the
ceiling bracket must be
installed to secure the
cover at the top.
To avoid unsightly gaps, plan the hood installation height
for duct cover use.
• The cover will fit a 12" min. height from the top of the
hood to the ceiling,
– or 24" min. and expanding up to 34" from the top of
the hood to the ceiling.
THE DUCT COVER CANNOT BE USED WHEN THE
DISTANCE ABOVE THE TOP OF THE HOOD IS
BETWEEN 12" AND 24".
Installation Instructions
fasteners, washers
12"
22"
12"
12"
11"
Screws, wall
2 Control Knobs
Review the following examples to ensure a trouble free
installation using the duct cover accessory.
8 ft. Ceilings: The hood must
be installed at 30" above the
cooking surface (or 66" above
the floor). The duct cover will
not fit if the hood is installed at
a lower or higher height. Use
the outside 12" section, discard
the inside section.
30"
24"
9 ft. Ceilings: Install the hood 24" min. and up to a maximum of 30"
above the cooking surface. The duct cover will expand to reach
ceiling height.
34"
32"
10 ft. Ceilings: Install the hood 32" min. to 36" max. above the cooking
surface. The duct cover will expand to a maximum of 34" above the
top of the hood to meet the ceiling.
12
Duct
Transition
with Damper
8 ft. Ceiling
12"
30"
9 ft. Ceiling
24"
30"
10 ft. Ceiling
30"
36" Max.
Filter
Support