Installation - Bosch Carephone 10 User Manual

Carephone 10
5

Installation

1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems
No programming of the Carephone is needed; your supplier has already done this. Place
the Carephone close to a mains socket and a telephone socket, it should be connected to
your first telephone socket. It can be placed on a table or mounted on a wall, the distance
between the screw holes is 135 mm.
Connect the Carephone's modem plug
directly into the telephone wall socket (a).
Connect the modular cord to the outlet
marked TELE on the backside of the Care-
phone and the modem plug. Thereafter, con-
nect the telephone's telephone plug into the
Carephone's modem plug (b).
Put the power adapter into an ordinary
mains socket and connect the cord to the
outlet marked POWER on the backside of
the Carephone.
When the Carephone leaves the factory, it's
preset for tone dialing (1). If your telephone
connection requires pulse dialing (2), this
must be set. The setting is done with a
switch located in the small compartment on
the bottom side of the Carephone.
Be sure that the wire aerial on the backside
of the Carephone (not on all models) hangs
freely, and that nothing covers the micro-
phone on the front of the Carephone.
Turn on the switch (ON) on the backside of
the Carephone (it must always be OFF when
the Carephone is not in use). The Carephone
is now ready for use. The LED indicator
should be green.
Make a test alarm by pressing your Wristband Transmitter. If you don't get in contact with
an Alarm Monitoring Centre, contact your supplier immediately.
OFF
User Manual
Installation | en
ON POWER TELE AUX
2
1
a
b
953.43d | v2.0 | 2009.01
11