Language; Locating Mode; Display Mode - Bosch NurseCall Main Unit User Manual

24 en | Programming
4.2.2

Language

Select the unit language.
¬ Language 0
English USA

4.2.3

Locating mode

NOTICE!
It is mandatory to perform a reset if you wish to change the value for the locating mode.
See Section 4.4.2 Resetting all the parameters, page 34.
Enable (ON) or disable (OFF) the indication of the transmitter position (locating mode) on the
NurseCall Main Unit display.

WARNING!
When the locating mode is disabled, the accompany mode, tracking function and dementia
criterion are no longer available in the parameters programming.
4.2.4

Display mode

NOTICE!
It is mandatory to perform a reset if you wish to change the value for the display mode.
See Section 4.4.2 Resetting all the parameters, page 34.
Select the display mode for the transmitters' identification.
1.
2.
1.
F.01U.252.699 | V1.1 | 2012.01
See Section 4.3.3 Programming the unit language, page 25 for more details.
LOCATING ?
( OFF / ON )
Press to disable or
DISPLAY MODE ?
(NUMBER / FL,RO,BE)
Press to select NUMBER or
If you select NUMBER, then you must choose between a 3-digit display (single number)
and an extended 4-sign display (digits and letters).
NUMBERING RANGE
(0-254 / 0-ZZZZ)
Press to select the 3-digit display 0-254 or
£
to enable the locating mode.
to select FL,RO,BE (floor, room, bed).
User Manual
NurseCall Main Unit
to select the 4-sign display 0-ZZZZ.
Bosch Security Systems