HP Surestore Tape Library 20/700
A5605A Expansion Frame Installation Guide
CAUTION: The HP tape library Expansion Frame is not customer installable or
replaceable. Any servicing, adjustment, maintenance or repair must be performed only
by authorized HP service-trained personnel.
Note to Customer Engineer: This installation may add new technology to the library
that older user's guides do not address. Please remind the customer that the latest user
documentation is available from the HP Customer Care website:
support.
Materials Included
Table 1. Materials List
Installation Notes
• Confirm with the customer System Administrator that the tape library can be powered
off.
• Observe proper power down and power on procedures, as described in the
Installation or Service Manual.
• If you install or replace an Expansion Module you must check mark the appropriate
box on the Drive Location Label. The Drive Location Label is located on the inside of
the library door, just below the UL label.
• Heavy Load. At least three people are required to remove the Expansion Frame from
packaging and push it into position.
Tools Required
Prior to beginning the installation process, obtain the following tools:
• 1/4-inch Ratchet Wrench
(for HP field service use only)
Part
I/I Expansion Frame
Expansion Frame Assembly
1/4-20 x 1/2-in. Torx Screws
Lock Down Latch Tool
62108
http://www.hp.com/go/
Quantity
1
1
6
1
1