Bosch LTC 8500 Instruction Manual page 82

EN | 72
• Error 70 - Monitor not allocated to alarm monitor group
This monitor can not be used for alarm operations; it has not been designated as
alarm-capable by the system programmer.
• Error 71 - Step monitor required
A group of alarm monitors may not have an armed Review (display) monitor
without having armed Step (sequence) monitors.
• Error 78 - Must enter alarm number
A specific alarm number must be entered when arming or disarming an alarm.
• Error 80 - Trunk not available
An attempt was made to access a remote camera connected to a satellite system,
but no unused trunk lines are currently available. Depending on system config-
uration and certain user options, the operator's monitor may automatically
switch to the default camera programmed into the Start-up column of the Moni-
tor Table when this error occurs.
• Error 81 - Satellite Trunk Seized
The camera currently viewed has changed because an operator with a higher
priority has selected a different camera that seized the trunk line from the satel-
lite. The operator's monitor will automatically be switched to the default camera
programmed into the Start-up column of the Monitor Table.
• Error 89 - internal stack error
A stack overflow within the system has occurred. Report this to the manufac-
turer.
• Error 90 - Keyboard entry undefined
The keyboard entry is not defined. Check the appropriate section of the instruc-
tion manual for the desired operation and try again.
• Error 92 - Keyboard entry out of range
The data entered for a valid command was not in the range allowed by the sys-
tem. Check the appropriate section of the instruction manual for the acceptable
ranges for the command in question and try again.
• Error 94 - Keyboard entry invalid
An invalid character has been received from the keyboard. Usually this would
indicate a communications error. Verify that the keyboard-to-system cable is not
producing an intermittent connection.
• Error 95 - Keyboard entry incomplete
The control sequence sent from the keyboard was incomplete. Usually this
would indicate a communications error. Verify that the keyboard-to-system
cable is not producing an intermittent connection.
• Error 96 - * (STAR) undefined
The * key has been pressed, but there is no definition for this button.
Bosch Security Systems | December 13, 2005