GE CW9000SDSS Use And Care Manual page 15

Read these instructions completely and carefully.
Slide the left corner into opening and push power cord into
the hole leading to the outlet location. Thread the cord
through as drawer is being pushed back into the opening.
If the outlet is installed inside the opening, plug the cord into
the outlet. In this location, the excess power cord should be
coiled and taped to the right side of the unit. Make sure the
cord does not get trapped by the drawer.
NOTE: Insure that the power cord does not contact the hot
surfaces on the bottom of ovens, cooktops, or any other
appliance.
Push the drawer back until the front flange is flush to the
cabinet front.
Open the drawer fully.
Drill pilot holes through the holes in the overlapping frame,
one on each corner.
Drive wood screws provided into each corner.
GEAppliances.com
15