Electrical Connections - Panasonic CQ-C3400W Operating Instructions Manual

Electrical Connections

E
N
G
L
Cable Wiring Diagram
I
S
H
23
(Only for CQ-C3400W)
Sub-Woofer Output Cord
(Only for CQ-C3400/C3100W)
CD Changer Input Cord
Changer Control Connector
Antenna
CQ-C3400W
CQ-C3300W
CQ-C3100W
Speakers
Rear Left +
(Green)
Rear Left –
(Green w/black stripe)
Front Left +
(White)
Front Left –
(White w/black stripe)
Front Right +
(Gray)
Front Right –
(Gray w/black stripe)
Rear Right +
(Violet)
Rear Right –
(Violet w/black stripe)
30
CQ-C3400/C3300/C3100W
S.W-OUT
CD.C-IN
L (White)
R (Red)
e Power
Preamp out Connector
Connector
(Pre-out) Rear
Preamp out Connector
(Pre-out) Front
Caution:
¡This unit is designed for use in a car having a 12-volt negative ground battery system.
¡To prevent damage to the unit, be sure to follow the connection diagram below.
¡Strip about 5 mm of the lead ends for connection.
¡Do not insert the power connector into the unit until the wiring is completed.
¡Be sure to insulate any exposed wires to prevent short circuiting with the car chassis. Bundle all cables, and prevent
cable terminals from touching any metal parts.
Fuse (15 A)
Refer fuse replacement to the
shop where you purchased
the product. Do not try fuse
replacement by yourself.
3
1
2
(Black)
ACC
(Red)
(Blue)
(Blue w/white stripe)
BATTERY 15A
(Yellow)
Ground Lead (Black)
To a clean, bare metallic part of the car chassis
Power Lead (ACC or IGN) (Red)
To ACC power, +12 V DC
Motor Antenna Relay Control Lead (Blue)
(To the auto antenna control power lead of the car.)
(Max.500 mA)
This lead is not intended for use with a switch actuated
Power antenna.
Amp. Relay Control Power Lead (Blue w/white stripe)
This lead is for connection to a Panasonic power
amplifier.
Battery Lead (Yellow)
To the car battery, continuous +12 V DC
CQ-C3400/C3300/C3100W
E
N
G
L
I
S
H
24
31