Electrolux ICON appliances Design Manual page 140

Trash Compactors
E15TC75HPS/E15TC75HSS (Combination)
planning
information
For models:
E15TC75HPS
E15TC75HSS
Note: For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Installation drawing shown
with professional series model.
Optional
Accessories
Deodorizing System
Replacement Disk
PN # ETC15ODH
60 Replacement Bags
PN # ETC15CB5DH
Toe Kick Accessory Kit
PN # ETC15TKH
140
specialty
Under-Counter Trash Compactors
Installation Specifications
• Product Weight – 161 Lbs.
• Voltage Rating – 120V / 60 Hz / 15 Amps
• Connected Load (kW Rating) @ 120 Volts = 0.15 kW
(For use on adequately wired 120V, dedicated circuit
having 2-wire service with a separate ground wire.
Appliance must be grounded for safe operation.)
• Amps @ 120 Volts = 5.5 Amps
• Electrical cable supplied.
• Always consult local and national electric codes.
• Can be used freestanding, or built in under counter.
(For conversion from built-in installation to freestanding,
use optional Toe Kick Accessory Kit – PN # ETC15TKH).
• Does not require additional airspace for top, sides or rear
when used in built-in application. Increase unit dimensions
by at least 1/4" for recommended rough opening, allowing
1-1/2" minimum clearance in rear for electrical connection.
• Unit MUST be level for proper operation, and positioned
on flat surface, capable of supporting entire weight.
• Leveling legs supplied to adjust height and level unit.
• Must be positioned to allow for 90° door swing. (Door is
field reversible for right- or left-hand opening.)
• When installing next to wall where handle may make
contact, allow 3" clearance between opened door and wall.