GE AEM12 Series Owner's Manual And Installation Instructions page 11

Installation Instructions
I-KIINSTALL THE CASE IN THE
WINDOW
[_] Open the window and mark the centerline
of the window sill.
['_ Carefully place the case on the window
stool and align the center mark on the
bottom front with the centerline of the sill.
['_ Pull the window down behind the top
mounting rail.
NOTE: Do not shut the window so tightly that
movement of the accordion panels is
restricted.
['_ Select the position that will place the sill
supports near the outermost point on the
sill. Place the short side of the sill supports,
on the case bottom, toward the window.
Attach the sill supports to the case track
hole in relation to the selected position
using 2 Type B screws in each support.
I I
Long side
of sill
supports
OUTSIDE
['_ Adjust the bolt and the nut in each
support so that the case is installed with a
slight tilt to the outside. Use a level; about
1/2 bubble will be the correct case slant to
the outside.
CAUTION: Ifthe sill
s upport
bolts do not contact the window sill,
or if you have a window without a sill,
you must order accessory kit RAK87 to
properly install this air conditioner. Call
800.626.2002 or visit ge.com.
1-81 INSTALL THE CASE IN THE
WINDOW (CONT.)
['_ Secure the case to the window sill by
using 3 Type D screws.
['G-] Pull the accordion panels to each window
sash track. Attach them on each side to the
window sash and the window sill using
4 Type C screws.
11