After Capturing An Image; Capture Images In Sequence - Nokia 5630 User Manual

Self timer — to activate the self-timer (main camera only). Select the
self-timer delay, and to activate the self-timer, select Activate.
Sequence mode
images in sequence,' p. 48.
Go to Gallery
To use panorama mode, select
panorama mode. Press the camera key to start capturing a panorama image. Turn
slowly to the right or left. You cannot change the direction. To stop the panorama,
press the camera key again. This option is available only for the main camera.
To customise the toolbar, select
item from the toolbar, or change, add, or move items.
The available options vary depending on the capture mode and view you are in.
The setup settings return to the default settings when you close the camera.
If you select a new scene, the colour and lighting settings are replaced by the
selected scene. See 'Scenes,' p. 49. You can change the setup settings after
selecting a scene if needed.

After capturing an image

After you capture an image, select the following from the active toolbar (available
only if Show captured image
• To send the image, press the call key, or select
• To send the image to a compatible online album, select
( )
• To open the Gallery, select
• If you do not want to keep the image, select
• To use the image as wallpaper in the standby mode, select
wallpaper.
• To set the image as a call image for a contact, select
contact.

Capture images in sequence

You can set the main camera to capture six images or more in a sequence. In the
active toolbar, select
camera key. To capture more than six images, press and hold the camera key. The
number of images captured depends on the available memory.
48
— to activate the sequence mode (images only). See 'Capture
— to open Gallery
Options
Options
is set to
Go to Gallery
Sequence mode
> Panorama mode.
> Customise toolbar. You can remove an
On in still image camera settings):
Send
( ).
Delete
> Burst. To capture images, press the
C a m e r a
indicates
( ).
Sign in for Share online
( ).
Options >
Options > Assign to
Set as