The Sequence Of Parameters Setting As Following; Date, Time Set-Up - Epson Weighing Indicator XK3190-A1+P User Manual

communication mode parameters.

(2) The sequence of parameters setting as following:

Connecting the loadcell , the indicator enters into working mode which is shown in
the Graph 2-3.
Insert the setting jumper into 15-pin socket at the back of indicator. (There is a 15-pin
plug in the packing carton with its 14-pin shorte connected with 15-pin. ).
Setup communication parameters as following:
Step Operation
1 Press[CALB]
2
Press[Enter]
3
Press[Enter]
4
Press[Enter]
5
Press[Enter]
6
Press[Enter]
Press[Enter]
7
Press[1]
Press[Enter]
8
Press[1]
Press[Enter]
9
Press[0]
Press[Enter]
10
( Please note the explanation. Don't change other parameters setting carelessly )

4.7 Date, Time Set-up

（1） Under weighing status of the indicator, press [ Date ] key, and date sign lamp is
lighted. Indicator display original data at this time. If it is correct, then press
X K 3 1 9 0 - A 1
Display
Plug in calibration jumper
[E **] Don't change this data and enter next step.
[dc **] Don't change this data and enter next step.
[Pon **] Don't change this data and enter next step.
[F Don't change this data and enter next step.
******]
[H *****] Don't change this data and enter next step.
[L *****]
[td **.**]
[A d r **] Communication address (01~26)
[A d r01 ] Example: 1
[bt *] Baud rate of serial communication (0~4)
which represent baud rate of
[bt 1] 600,1200,2400,4800,9600
[tF *] Serial communication mode:
[tF 0] 0- Continous transmitting mode,
unreceiving
1- command responding mode
Weighing End of communication parameters setting
mode
+P
Explanation