Keystone correction attaching ceiling Projection Lamp mount bracket Type Power consumption Lamp life Part number 12/07 Epson PowerLite 6110i Opens menu system Up/down arrows and keystone correction Cancel/exit Opens help system Left/right arrows Enter button and Volume automatically adjusts down/up...
Choose Rear/Ceiling If the projector is tilted in the front or the back, you may need to adjust the image shape. See page 7. Image Size and Projection Distance The distance between the projector and the screen determines the basic size of the projected image, as shown below.
See “Adjusting the Image and Presentation” on page 6. Follow these steps to plug in and turn on the projector: 1. Plug one end of the power cable into the projector, and the other end into a grounded electrical outlet.
It may be labelled or have an icon such as CRT/LCD You may have to hold down the Allow a few seconds for the projector to sync up after changing the setting. The Projector and Notebook Don’t Display the Same Image If you’re projecting from a notebook, and you can’t see your...
If the image is too low on the screen, you can use the front ® technology, there’s no adjustable feet to raise it. 1. Lift the front of the projector and turn the front feet to adjust the position of the projected image. 12/07 ring to sharpen the image.
If the projector is slightly tilted (within a range of 30° up or down), you can use the buttons on the projector’s Keystone control panel or the projector’s Keystone menu (see “Using...
Page 8
Epson PowerLite 6110i Switching Between Picture Sources If your projector is connected to more than one computer and/or video source, you can switch between the different sources: ❏ On the projector’s control panel, use the button to switch between equipment connected to the...
ID to zero. Setting the Projector ID The projector’s default ID is set to Off. This lets it respond to commands from any remote control. To change the ID, follow these steps: 1.
Page 10
The lamp may be burned out. First make sure the lamp cover is securely installed. If that’s not the problem, remove the lamp and replace it as described on page 13. If this does not resolve the problem, contact Epson.
Settings menu. (See the User’s Guide for more information.) Using the Navigation Buttons The remote control has various buttons that let you navigate the projector’s help and menu systems; they also let you use the drawing tools to highlight your presentation. Enter button Esc button...
1. Turn off the projector and unplug the power cord. 2. Lift the air filter cover by pulling up the tabs. 3. To clean the filter, Epson recommends using a small vacuum cleaner designed for computers and other office equipment. If you don’t have one, gently clean the filter using a very soft brush (such as an artist’s paint brush).
In the unlikely event that the lamp has broken, small glass fragments may be present and should be removed carefully to avoid injury. 3. Let the projector cool for at least an hour (if it has been on). The lamp is extremely hot immediately after use. 12/07...
❏ When transporting the projector a long distance, first place it in a hard-shell shipping case, and then pack it in a firm box, placing cushioning around the case. Note: Epson shall not be liable for any damages incurred during transportation. 12/07...
Optional Accessories You can purchase accessories for your projector from an Epson authorized reseller. To find the nearest reseller, call 800-GO-EPSON (800-463-7766). Or you can purchase online at www.epsonstore.com (U.S. sales) or www.epson.ca (Canadian sales). Accessory Replacement lamp High efficiency air filter (standard)