Epson USN 52R Operating Manual page 92

Configuring the USN 52R/USN 52L
FILE NUMBER Selecting a file
In this function you enter the number of FILES for the
Data Logger. You can also select specific measured
values here. The indicated functions are:
• ALL CLEAR: No files have been configured
• FILE NUMBER # 1-99: Enter number of files
• ALL FILES: When there are configured files
• EMPTY: (before file number) No reading stored
• ACTIVE: (before file number) Reading stored
• FULL: (before file number) No measurement
locations free
Operation:
– Hightlight the right function group in the left function
table with I.
– With M select the required setting.
H Note:
More detailed information about operation of the Data
Logger can be found in Chapter 5.5.
Krautkramer USN 52R/USN 52L
LOCATION
Set the measurement location at which the next mea-
sured value is to be stored.
Operation:
– Highlight the right function group in the left function
table with I.
– With M select the number of the required
measurement location.
– If you wish to return to LOCATION 1, press N and
O simultaneously.
Issue 05, 02/00
Selecting the measurement
location
Operation
5-47