Table of Contents
Advertisement
4. Attach light reflector in place with the two screws
removed during Step 2 in SECTION 1 Preparing the
Unit so grill fits snuggly against ceiling (Figure 14).
Figure 14
CAUTION:
FAILURE TO SECURE THE REFLECTOR
SCREWS MAY RESULT IN A RATTLING OR HUMMING
NOISE.
5. Install a 100 watt maximum, type A19 medium base
incandescent bulb (not included).
6. Close the light lens and secure in place by swinging
back into position and snapping the tabs in place
(Figure 15).
Connector Bar
Figure 15
7. Restore power and test your installation.
Trouble
1. Fan does not operate when the switch is on.
2. Fan is operating, but air moves slower than normal.
3. Fan is operating louder than normal.
210572111 Rev. B 5-06
Screws
Tabs
Troubleshooting Guide
Probable Cause
1a. A fuse may be blown or a circuit tripped.
1b. Connector plug from motor is not plugged in.
1c. Wiring is not connected properly.
2. Obstruction in the exhaust ducting.
3a. Motor is loose.
3b. Fan blade is hitting housing of unit.
www.geelectrical.com
SECTION 7
Use and Care
CAUTION:
MAKE SURE POWER IS SWITCHED
OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT.
1. Cleaning the Grill: Reverse the instructions in Section
6 Completing the Installation to remove grill. Use a
mild detergent, such as dishwashing liquid, and dry
with a soft cloth. NEVER USE ANY ABRASIVE PADS
OR SCOURING POWDERS. Completely dry grill before
reinstalling. Refer to instructions in Section 6
Completing the Installation , to reinstall grill.
2. Cleaning the Fan Assembly: Wipe all parts with a
dry cloth or gently vacuum the fan. NEVER IMMERSE
ELECTRICAL PARTS IN WATER.
CAUTION:
ALLOW BULBS TO COOL BEFORE
REPLACING.
3. Changing the Light Bulb: Disconnect power to the
unit. Open light lens by pushing in on the two tabs
of light lens and pulling outward from lens. The lens
will swing open on the connector bars. DO NOT
remove the lens from the grill (Figure 16).
Connector Bar
Figure 16
4. Unscrew bulb from lamp holder and replace with a
100 watt maximum, type A19 medium base
incandescent bulb.
Suggested Remedy
1a. Replace fuse or reset circuit breaker.
1b. Turn off power to unit. Remove Grill and plug motor into
receptacle in housing. Restore power to unit.
1c. Turn off power to unit. Check that all wires are connected.
2. Check for any obstructions in the ducting. The most common
are bird nests in the roof cap or wall cap where the fan
exhausts to the outside.
3a. Turn off power to unit. Remove grill and check that all screws
are fully tightened. Restore power to unit.
3b. Call your dealer for service.
Tabs
5 of 8
Advertisement
Table of Contents
