Page 1
Analog Video Input Board For NTSC (525i): For PAL (625i): Operating Instructions...
Page 2
CAUTION: TO REDUCE THE RISK OF FIRE OR SHOCK HAZARD, REFER MOUNTING OPTIONAL INTERFACE BOARD AUTHORIZED SERVICE PERSONNEL. indicates safety information. Precautions O Do not touch the product with wet hands. O Do not drop the product or expose it to bumps or shocks. O Do not attempt to modify the product.
Installing the board CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire or electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Disconnect the power cord from the VTR.
Page 4
Installing the board Loosen the screw indicated in the diagram below, then remove the board clamp. Board clamp Screw Insert the analog video input board into the slot marked F2 located on the rear panel side of the VTR. 4 (E)
Installing the board Reattach the board clamp using the screw, then fix the top panel in place using the 2 coin screws. Board clamp Screw Specifications Dimensions (WaHaD): inch (127a148a15 mm) Weight: 0.275 lb (125 g) Analog component input: BNCa3 (Y, P Y: 1.0 V [p-p], 75 Ω...
Page 6
PANASONIC BROADCAST & TELEVISION SYSTEMS COMPANY UNIT COMPANY OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA Executive Office: One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7000 EASTERN ZONE: One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7621 Southeast Region: 1225 Northbrook Parkway, Ste 1-160, Suwanee, GA 30024 (770) 338-6835...