Hewlett-Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. Hewlett-Packard assumes no responsibility for the use or reliability of its software on equipment that is not furnished by Hewlett-Packard.
hp server rp54xx System Safety and Regulatory Information Overview Regulatory Compliance statements are required by some countries for international importation of hp server rp54xx products. The following information is provided: Regulatory Information Electrical Safety — Electrostatic Discharge (ESD) Precautions — Battery Notice Cabinet Safety Precautions Declaration of Conformity FCC Statement (USA Only)
Page 4
Battery Notice This product contains a Lithium battery. This battery is not to be removed or replaced by the user. If the battery needs to be replaced, contact your Hewlett-Packard authorized service personnel. CAUTION Lithium batteries may explode if mistreated.
Cabinet Safety Precautions WARNING Cabinets are heavy even when empty. Exercise caution when moving cabinets whether equipment is installed in the cabinet or not. Avoid rolling cabinets on rough or uneven surfaces or inclines greater than 10 degrees. Unloading cabinets from the pallet and movement of cabinets should be performed by at least two people.
Page 6
Procedimentos de Segurança - Armários ATENÇÃO Os armários são pesados, mesmo quando vazios. Tenha cuidado ao movimentar os armários, quer haja equipamentos instalados quer não. Evite deslizar os armários sobre superficies acidentadas, irregulares ou com inclinação superior a 10 graus. A retirada dos armários do palete e sua movimentação deverão ser feitas por, no mínimo, duas pessoas.
Page 7
Säkerhetsföreskrifter för kabinett VARNING Kabinetten är tunga även när de är tomma. Var försiktig när du flyttar ett kabinett, oavsett om det är tomt eller innehåller utrustning. Undvik att rulla kabinett på ett underlag som är ojämnt eller lutar mer än 10 grader. Det krävs minst två personer för att lasta av ett kabinett från transportpallen eller för att flytta det.
Page 8
Voorzorgsmaatregelen voor de veiligheid voor kasten WAARSCHUWING Kasten zijn zwaar, ook als deze leeg zijn. Ga voorzichtig te werk als u een kast verplaatst, of er nu wel of niet apparatuur in de kast is geïnstalleerd. Rol kasten niet over ruwe of ongelijke oppervlakken of hellingen van meer dan 10 graden.
Page 9
Sikkerhedsforanstaltninger for skabe ADVARSEL Skabene er tunge, selv når de er tomme. Vær forsigtig når De flytter skabe, hvad enten der er installeret udstyr i skabet eller ej. Undgå at rulle skabe på ru eller ujævne overflader eller skråninger der hælder mere end 10 grader. Der skal mindst to personer til at aflæsse skabe fra pallen og til at flytte skabe.
Page 10
Sikkerhetsforanstaltninger for skapene ADVARSEL Skapene er tunge, selv når de er tomme. Vær forsiktig når du flytter skap, uansett om de er tomme eller inneholder utstyr. Ikke rull skap på ru eller ujevne overflater eller i skråninger som heller mer enn 10 grader. Det trengs minst to personer til lessing av skap fra pallen og til flytting av skap.
Page 11
Laitekaappia koskeva turvavaroitus VAROITUS Kaapit ovat tyhjinäkin painavia. Ole varovainen siirtäessäsi kaappia siitä riippumatta, onko siihen asennettu laitteistoa. Älä rullaa kaappeja karkeilla tai epätasaisilla pinnoilla tai jos pinnan kaltevuus ylittää 10 astetta. Kaappien ottamiseen alas lastausalustalta ja niiden siirtämiseen tarvitaan ainakin kaksi henkilöä.
73/23/EEC and the EMC Directive 89/336/EEC and carries the CE marking accordingly. 1) The product was tested in a typical configuration with Hewlett-Packard computer peripherals. 2) DC versions of the product were tested in a typical configuration with a Hewlett- Packard 6813A AC/DC power source.
HP shielded cables, such as those you receive with your computer. Changes or modifications not expressly approved by Hewlett-Packard could void the user's authority to operate the equipment. Cables used with this device must be properly shielded to comply with the requirements of the FCC.