Technical Data - Bosch THD2021GB Instructions For Use Manual

10
Problem
The temperature of the water
drawn is too low.
Water is collecting in the water
outlet.
The O symbol is lighting even
though there is a sufficient
amount of water in the water
tank.
N lights up after only a few
drawing cycles.
N lights up even though a filter
has been used.
N lights up even though the
appliance has just been
descaled.
Loud "cooking and pumping"
noises are heard during the
drawing process.
N, M and O are all flashing at
the same time, it is not possible
to draw any water.
If you are unable to rectify the problem, please contact Customer Service.

Technical data

Power connection (voltage/frequency)
Heater wattage
Maximum static pump pressure
Maximum water tank capacity (without filter)
Length of power cable
Dimensions (H x W x D)
Weight, empty
Robert Bosch Hausgeräte GmbH
Possible cause
The temperature set displays the
water temperature directly at the
water outlet.
The glass or cup is too cold.
There is a build-up of limescale
in the appliance.
Condensation water may result
due to physical properties.
The float in the water tank is
stuck.
Possible operating error.
Even filtered water contains low
amounts of calcium carbonate.
The descaling programme was
interrupted because of, for
example, too little water or a
power failure.
The filter is set to "yes" (see
chapter " BRITA MAXTRA
water filter system") but there
is no filter in place. Build-up of
limescale in the appliance.
The used water is particularly
calciferous. Build-up of
limescale in the appliance.
The appliance has a fault.
Remedy
Select a higher temperature.
Rinse out the glass or cup with hot
water before filling it or draw water
first to heat it up.
Descale the appliance as
described in the instructions.
With extremely calciferous water,
descale the appliance more often
than the symbol is displayed.
It is normal for condensation to
appear, simply wipe it away.
Clean the water tank and release
the float.
Descale the appliance as
described in the chapter
"Descaling".
Descale the appliance as
described in the chapter
"Descaling".
Carry out the descaling programme
again as described in the chapter
"Descaling".
Descale the appliance as
described in the chapter
"Descaling".
Finally, programme the correct
setting.
The appliance must be descaled
more often than the N symbol lights
up. Follow the instructions outlined
in the chapter "Descaling".
Disconnect the appliance from
the power supply and contact
Customer Service.
220-240 V / 50 Hz
1600 W
3.3 bar
2 litres
80 cm
290 x 223 x 267 mm
2.3 kg
en