Panasonic 30 - Toughbook - Core 2 Duo Service Manual page 33

■ Assembly of Inverter PCB (Applicable Model : Touch Screen Model)
Inverter Ass'y
Confirm the direction of the Inverter board when attaching.
Inverter Mil Sheet
30 35mm
The gap side is front.
Inverter Ass'y
Details of cable
Attach coming over the end of steel plate by 1 to 2 mm.
0 1mm
Insert it between the ribs.
(Fit to the Cabinet.)
LCD Side Cushion E
Insulation Parts
LCD Ass'y
Details of "A"
Ensure the edge of the
conductive fabric is not
frayed.
1 2
mm
S5
Avoid running over the rib
S2
Attach it to the Connector and FPC.
12
FPC
TS PWB
LCD Side Cushion F
Insulation Parts
Connect
Inverter Ass'y
Connect the Cable to the
0 0.5mm
left and right Connectors.
Sub material: Pet Tape 1
Avoid any stress on the Cable
when connecting it.
Hold the Connector part when
connecting/disconnecting.
LCD Cable TS
Wind round the LCD Cable
a few times and attach it.
Sield Sheet
Fix the two Cables
and connector.
Avoid getting under the Sheet.
A
Insulation Parts
Insulation Parts
Connect
Avoid any stress on the Tab part of the
LCD Module because the line comes off.
Wrap of Antenna Cable
Cushion E
Safety Working
S1:Insulation S2:Pinching Cables S3:Sharp Edge
CAUTION
S4:Part No. Check S5:Others
33 / 90
Avoid any stress on the Cable when
connecting the CCFL Cable.
Hold the Connector part when
connecting/disconnecting.
LCD Side Cushion E
Connector
Insert it between the ribs.
PWB
(Fit to the Cabinet.)
Cushion High
Voltage Label
Insert it between the ribs.
(Fit to the Cabinet.)
0 3mm
Tape
Attach the Inverter Ass'y in the
middle of right and left.
Attach the surplus of the right and left sides on the
Back Dumper as shown below and overlap on the
CCFL Cable. Attach the Pet Sheet over the Core.
Note for attaching Conductive Tape
Conductive Tape
Inverter Ass'y
LCD Back Dumper
0 4mm
6 2mm from the
branch point
Conductive Tape
Wrap over the Antenna Cable
Cushion and the Cable.