B4 (JB4) (10.1 × 14.2 inches) 1 W or less in power off mode 11 × 14 inches Check the label on the back of your printer for voltage information. 30 × 40 cm (11.8 × 15.7 inches) 10/07 Epson Stylus Pro 11880 - 1...
Cut sheets Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, Epson cannot attest to the A3 (11.7 × 16.5 inches) quality of any non-Epson brand or type of paper. Always test samples US B (11 ×...
T591400 button Note: Paper Paper source Paper feed Take-up We recommend that you use genuine Epson cartridges and do not light light or cut button down button reel refill them. The use of other products may affect your print quality Forward and could result in printer damage.
Adjusts the contrast of PAPER FAST, THICK ADJUSTMENT the LCD display PAPER SLOW PAPER FEED ADJUST –0.70% to 0.70% DRYING TIME 0. 0 sec. to 10.0 sec. STANDARD, –1, –2, –3, PAPER SUCTION –4 4 - Epson Stylus Pro 11880 10/07...
If ink gets in your eyes, flush them immediately with water. To prevent ink reporting errors, never replace the ink cartridges with the printer turned off. 10/07 Epson Stylus Pro 11880 - 5...
Banding can be caused by several problems, such as clogged print head nozzles or a misaligned print head. It can also be caused by using a paper that is not defined in the Epson printer driver or in a third-party RIP. To correct this problem, make sure you select the correct paper type in the driver.
You can run a power cleaning cycle from the control panel (or from the Epson LFP Remote Panel) if the normal cleaning 1. Make sure the printer is turned on. Then load Epson process is not sufficient to clear the nozzles. However, the...
8. Release the side pin carefully. The cutter pops out. : The blade is sharp. Be careful when removing it. WARNING 3. Close the front cover. The cutter moves to the home (far right) position. 8 - Epson Stylus Pro 11880 10/07...
You can check how much space remains in the maintenance tanks by viewing the gauges on the control panel, shown below. You can also check the tanks using Epson Status 5. Insert the new tank all the way into its compartment.