Table of Contents
Advertisement
Installing a NIC on the Nokia 100i Gateway
Note
f you cannot access the power switch, you can still perform this
procedure. When the slide tray assembly is removed from the chassis
assembly, power to a Nokia 100i is automatically disconnected.
To physically install a NIC on the Nokia 100i gateway
1. Identify the location (PMC carrier and slot) of the NIC to be replaced.
2. Turn off the power switch on the rear of the gateway and unplug the
3. IUse your fingers or a screwdriver to loosen the retaining screws that hold
Nokia 100i Installation Guide
power cord.
the chassis assembly.
Chassis assembly retaining screws
Installing a Network Interface Card
00248a
49
Advertisement
Table of Contents
