Related Manuals for Haier HWF05XC5-T
Summary of Contents for Haier HWF05XC5-T
- Page 1 SPEED COOL COOL FAN ONLY POWER Wait 3 Minutes Before Restarting HWF05XC5 HWR05XC5 0010551959...
- Page 5 8-11 8-11 12-16 14-16 17-18 18-19...
- Page 6 2 . Press ìtest ìbutton, unit should trip. 3. Press ìresetî button again for use . Do not use if above test fail. In the event this device trips , the cause of the malfuncti be corrected before further use of the device .
- Page 8 2-way access panel airflow filters SPEED COOL COOL FAN ONLY POWER Wait 3 Minutes Before Restarting MODEL: HWF05XC5 2. MODE Set Switch...
- Page 9 2-way access panel airflow filters TIME ON TIME OFF HI SPEED LOW SPEED COOL POWER ON/OFF MODEL: HWR05XC5 2. fan Speed Pressing the Fan Speed button of remote control between High and Low speed.
- Page 10 MODEL: HWF05XC5 SPEED COOL COOL FAN ONLY POWER Wait 3 Minutes Before Restarting...
- Page 11 Normal Fan 1. Turn the SPEED mode switch to the "HI" or the "LOW" setting. 2. Set the thermostat control to the temperature mark "FAN ONLY". Normal cooling 1.
-
Page 12: Control Panel
MODEL: HWR05XC5 Control Panel ON/OFF TIME ON TIME OFF MODE SPEED TIMER HI SPEED LOW SPEED TEMP/TIME COOL POWER ON/OFF... -
Page 13: Timer Off
1. ON/OFF To turn set ON, press the button. To turn set OFF, press the button again. 2. TIMER Press TIMER button, for each press, TIMER mode will changes as follows: TIMER ON TIMER OFF CANCEL 3. FAN Pressing the FAN button changes between LOW and HIGH SPEED. - Page 15 31/32" top rail window seal gasket short screws 13/32" Model: HWF05XC5 wood screws 31/32" top rail window seal gasket ON/OFF MODE SPEED TIMER short screws 13/32" TEMP/TIME Remote ìCR2025ì battery control Model: HWR05XC5...
- Page 16 Wait 3 Minutes Before Restarting HWF05XC5,HWR05XC5 ASSEMBLE CURTAINS/TOP RAIL Install top rail with 3 short screws13/32". Insert the side curtains into the top and bottom rails of the air conditioner. Fasten the curtains to the unit with 8 short screws 13/32".
- Page 17 (OUTER SILL) to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise the height of 1 MAX. the window sill so that the unit can be installed without interference by...
- Page 18 INSTALL THE AIR CONDITIONER WINDOW FRAME IN THE WINDOW UPPER GUIDE Carefully lift the air conditioner and slide it into the open ABOUT 1/4 window. Make sure the bottom guide of the air conditioner drops into the notches of the basepan angle.
- Page 19 How to remove the air filter 1. The grille may be opened from the top for easy maintenance after inst 2. Open the inlet grille by pulling off the exposed door on the top of t on the installation). 3. Pull the tab slightly to release the filter. Pull the filter in the sa the opening.
- Page 21 (see page 8) (see page 16)