Advertisement
• For best operating performance, see
section 5-B.
2>A Making Calls
1
Press
/FLASH].
•The IN USE indicator lights.
• If an alarm tone sounds, see section 5-F.
2 Dial a phone number.
3
To hang up,
press [OFF] or place the handset on
the base unit.'
•The indicator light goes out.
•If additional dialing is necessary after using speed
dialing functions such as AUTO (3-B) or REDIAL,
wait until speed dialing is finished to continue
further dialing. Otherwise, the unit may not dial
properly.
To redial the last number dialed
Press [STflash] ^ [pauseVredialI.
To select the receiver volume
4 levels (HIGH, MEDIUM, NORMAL, LOW) are
available.
Press (LOUD) while talking.
•Each time you press (LOUD}, the volume level will
change.
If noise interferes with the
conversation
Press fCHl to select a clearer channel or move
closer to the base unit.
2-B Answering Calls
Lift the handset off the base unit and
press I
*>/FLASH].
•You can also answer a call by pressing any
button except [OFF] (—Any Key Talk).
Selecting the ringer volume
Set the RINGER selector to ON or OFF.
•When set to OFF, the unit will not ring.
l3\
Speed Dialer
Section 3
3-A storing Phone Numbers in
Memory
• If a pause is required for dialing, press
1 PAUSE/REDIAL 1 where needed. Pressing
1 PAUSE/REDIAL 1 counts as one digit (4-D).
[PAUSE/REDIAlJ
You can store up to 10 phone numbers in the handset. The
dialing buttons ((o) to @) function as memory stations. The
IN USE indicator light must be off before programming.
If you misdial
1
:
Press
(AUTO/PROGRAM]
Press [OFF] to end storing. ^ Start
step 1.
again from
The IN USE indicator flashes.
To erase a stored number
(•% /FLASH]
.IN USE
Indicator
Press a memory station number ((o) to [s))-
Memory
Station
Numbers-
•po^
'OiOS
o<2T
Enter a phone number up to 16 digits.
Press
(AUfo7PRbGR AM
I ^ the memory station
number ((o) to (§}) for the phone number to be
erased ^
[AUTO/PROGRAMl.
•A beep sounds.
Press
(AUTO/PROGR^.
»A beep sounds.
•To store other numbers, repeat steps 1 through 4.
3-B Dialing a Stored Number
I AUTO/PROGRAM)
Press
[*>/FLASH] ^ (AUTO/PROGRAM] ^
the memory station number ((o) to (D).
For assistance, please call: 1-800-211-PANA(7262)
Advertisement
