Electrolux ELFE763CAT Use & Care Manual page 16

16
INSTALLATION
Reversing the door

NOTE
Door reversibility is available on all models.
IMPORTANT
BEFORE YOU REVERSE WASHER DOOR:
1. Be sure you have adequate swing area before reversing
door.
2. Gather your tools - including a screw driver with a #2
square bit and plastic knife (or small, flat prying tool that
won't damage paint).
3. Protect flat work surface, such as top of washer or floor
near washer, with a soft cloth or towel.
4. Be sure washer is unplugged from power source!
WARNING
Failure to disconnect power source before servicing could result in personal injury or
even death.
Removing door assembly
1. Completely open the door to expose
all four hinge screws.
2. Remove all four hinge screws with #2
square bit driver. Save for reinstalling later.
x4
Fine Thread
3. Hold the door with one hand
supporting the handle area and one
hand supporting the hinge. While
supporting the door at the hinge, press
firmly with the other hand until the
locating pins on the back of the hinge
plate dislocate from the front panel.
ELECTRICAL SHOCK HAZARD
4.
Take care not to pull the door away from
the washer until you remove the wiring
harness terminal cap.
5.
Tools needed for
While supporting the door with one
hand, pinch the tabs to release the
plastic terminal cap from the hinge
plate.
IMPORTANT
Set the door face down on a flat
surface protected by soft cloth or
towel.
reversal:
Screwdriver
with #2
square bit
Plastic knife